Recent content by Chuck17

Where do I go to look up the maintenance display codes on the CP Card? The code that is displayed is Running Rom OS entering CP Vote. How do I clear this code?

When I loose call processing I don't have dial tone at all. The only way I can remedy the problem, is by INIing the switch, but I can't keep doing that.

I'm have intermitent problems with an opt61c. First, I loose any ability to dial out via, no call processing. Second, I have a red L.E.D constantly lit on the backplane of one of my Core/Net module, right behind the 3PE card. Third, on the CP card I have a maintenance diplay message of 8A SDI...

Thanks guys for the info...

How can I block an incoming call within a Meridian 1? The reason behind the question is, I'm receiving about 20 calls a day from what sounds like a fax machine on the other end, and I would like some info. on stopping that number from being terminated inside our telephone switch.

All, Does anyone out there have checklists with power up /power down procedures for the meridian 1? If so, please attach them to your reply. Thanks in advance.

Thanks for all the helpful information... Chuck

Hello All, Does anyone know of a good Call Accounting Software package that can be used with a Meridian 1 system.

Has anyone connected an Algo external ringer to a meridian phone? If so, how did you do it. I have an external alerter board install in side the phone, but it does not work. Any help would be greatly appreciated. Chuck17

I would like to thank Colin, for the the help. A Co-worker of mine contacted tech support and they loaded used a high level password to log into the switch and turn the Lampaudit on. Thanks for the help Chuck

No, I'm in the US...It has come to my attention that a software patch is needed to correct this error. Have you had a problem like this before. Chuck

The system would not let me input anything after DLMP This is what I entered DLMP Then right after I enter the 'DLMP', the system outputs the following: ? SYNTAX Chuck

I tried to turn on the Lamp audit in LD 77, but everytime I input DLMP, the system outputs '? syntax'. It doesn't allow me to enter 0/1.

Guys, I trying to find out how to clear a SCH6451 error message, any help would be greatly appreciated.