Recent content by Chris78

Eugene, are you able to do a dd (read) command on the rhdisk such as : dd if=/dev/rhdiskXX of=/dev/null bs=512 count=10000 if errors exists, you've got another problem Chris

Hi driddickemc, under ECC 5.2 in the alert def policy, you can enabled the call-home alert. Chris

hi breslau, it depends on which hba you used, for instance on emulex, you can set the queuedepth using elxcfg (in scsi mini port), see http://www.emulex.com/ts/docfc/winnt4port/4221a8/introconfig.htm hope it can help you. Chris

Hi Driddickemc, Chacalinc is right, try 'lscfg -vl fcsX' for each of your adapters in order to see the WWN (must be Z8) and the firmware (must be Z9). Hope it can help you Chris

I am trying to run a Oracle Agent from ECC 5.2 The app doesn't run and complains that a set of symbols are not exported from "/unix". Actually these symbols are defined (as seen in dump -Tv output) in shr.o module in /unix. exec(): 0509-036 Cannot load program...

Hi, The solution was to swap the DS-16B2 switch then on the new one, the upgrade from 3.1.2a to 3.1.3 has worked fine. Christian

ok, So think you must in FC-SW protocol, means that the VCM bit must be set on the FA connected to your host ; so it means that you must at least see a little device named 'vcm' which is write-disabled. Other thing to check on your host side : -I suppose that you must have a LP9xxx hba so you...

Hi TekieMDX, Which license are set under Solution Enabler 5.4 ? (check the symapi_licenses.dat) The server where you run the command is attached to this DMX box ? throught a switch ? (if yes, zoning switch is ok and activated ? are there some gk configured too ? what is the result of a "symcfg...

Hi folks, I'm trying to upgrade a DS-16B2 switch from 3.1.2a to 3.1.3 but I've still have the same error message "writing flash 0 ................tslog is not initialised, use tsLogInit to initialise." then it reboot with a recover process back to 3.1.2a. Any idea ? TIA Christian

Hi hugonovo, What Chacalinc said is right, if you want to be able to see new device without reboot, complete every target from 1 to 255 and luns from 0 to 255 ; btw if your Sun server got the latest generation of fiber hba (leadvill driver) you can add news devices without reboot and without...

Hi Coolice, Describe your configuration (how many AIX, Sun, HP servers with symmetrix agents, host agent, master agent, etc...) Christian

Hi Schweigstill, Chacalinc is right, there is a lot of action to do !! which microcode is it ? how many SA / FA do you have ? which protocol on FA ? volume mapped on SA / FA ? masking to do... Christian

Hi Amins, In fact, you can increase a meta-volume under Win2K or Win2K3, the only problem is this process is only supported in 68 (the top level) and not supported in the last microcode (69 and 70 for DMX). In summary (because, it's a little bit long process :-) you must have a BCV meta which...

Ok test done VBit on = HBAnyware show some LUN 16XXX VBit off = HBAnyware show normal LUN X Thanks for your answer Christian

Hi Chacalinc and thanks for the feed-back, In fact, we got this situation since the begining of the installation. The configuration is as follow : Symmetrix #xxxx | | FA-WW-port X FA-YY-port Z | | DS16B...