Recent content by Chopard

On further investigation - it appears that I may have a hardware issue with the changer. The changer I use has a robotic arm that goes through and scans the slots for tapes/barcodes and moves media when required. It appears that the robotic arm has got it's self in a loop of continually...

Urgh, I'm getting this same problem now myself and I'm wondering if anyone knows or remembers what their solution was. I've checked the Veritas site and can't find any help there. I'm using B.E v9.1. I have two changers attached, each with two drives. One of the changers is working fine...

Yes, we're having the same problems as well. We've also found that there are quite a few tapes (atleast 2 so far out of about 10 tapes used) that seem to be bad even though they are all brand new tapes. We have only recently setup the new jobs on the new hardware so we haven't had the jobs...

With older versions of Backup Exec the emails use to be able to contain the job name and then the job completion status (successful/failed). With BEv9.0 I can't seem to figure out how to get this to work. The job name is in the body of the email instead of the subject and with several jobs...

I use exactly the same setup here. (Same tapes/changer/version of BE) Some of our tapes have the same issue but it seems that it is only the tapes that have only backed up less than 100GB of data that show incorrect capacity. Once we've gone over the 100GB capacity it seems to show the...