Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Wanet Telecoms Ltd on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by chonet4444

  1. chonet4444

    MQSeries IPT Install Issue

    I'm installing MQIPT on an HP-UX. I followed the directions on how to install MQIPT on an HP-UX server. 1st I uncompressed the ms81_hp11.tar.Z. 2nd I tar -xvf ms81_hp11.tar. 3rd I removed the tar file. 4th I did swinstall -s /tmp MQIPT.MQIPT-RT and got error #1. Then I tried swinstall -s...
  2. chonet4444

    2948G-L3 protocol prioritization

    Does anyone know if the routing module on a Catalyst 2948G-L3 supports protocol prioritization? Regards, halim
  3. chonet4444

    Configuring VLAN on Catalyst 2948G L3

    Thanks for the help. Now for a twist on the setup. What about vlans involving a Cisco 2948G-L3 and Nortel Accelar 8010? What "gotchas" should I be looking out for when setting up vlan with these two devices? Regards, Halim
  4. chonet4444

    Configuring VLAN on Catalyst 2948G L3

    I would like to configure 2 VLAN's on the switch. One port would be xxx.xxx.2.192 and the other would be xxx.xxx.4.192. Is it possible to route traffic from a PIX 515UR to the 2 VLAN's? How do I route traffic between the two VLAN's? Is there a good sample config for me to follow? I'm new to...
  5. chonet4444

    Basic setup

    I would also like help with the same problem. Cisco support advised to create a static (inside) xxx.xxx.14.0 xxx.xxx.14.0 netmask xxx.xxx.xxx.xxx. This did not solve the problem. I've pasted a copy of my config file: Building configuration... : Saved : PIX Version 6.1(1) nameif ethernet0...
See more

Part and Inventory Search

Back
Top