Recent content by cherisc

Yes, I want the SonicWALL to be the NAT device, and I want to turn NAT off on the Cisco. I believe I figured it out, I need to enter more routes on the SonicWALL. I'll post tomorrow.

This is not working. When I take out the NAT commands, I get no Internet. Here is my running config no service pad service tcp-keepalives-in service timestamps debug datetime msec localtime show-timezone service timestamps log datetime msec localtime show-timezone service password-encryption...

Is there enough memory in the router to support the new IOS?

I'll try that. Thank you. I haven't worked with Ciscos in over 3 years, so this is all coming back to me.

Hello, I have a network with a Cisco 2800 that was the firewall for the network. I placed a SonicWALL router between the Cisco and the T1 Internet connection. The cisco is currently using NAT, so that the SonicWALL logs are all showing the IP address from the connected Cisco IP address. Here...

I have purchased a smartnet agreement. I am going to attempt to upgrade the IOS after I get the agreement. I have never upgraded a cisco router, and any suggestions would be great. I will keep posted on how that goes and I'll let everyone know when I get the router working. Thank you

The "00:28:14: %PQUICC-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem?" error only occurs if I physically disconnect the dsl line from the cisco. I'm faced with the problem of getting the adsl line to communicate with the ISP. I still get the "cannot place call no dialer string set" error...

Here is a show ver: Cisco Internetwork Operating System Software IOS (tm) C827 Software (C827-Y6-M), Version 12.1(1)XB, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1) Copyright (c) 1986-2000 by cisco Systems, Inc. Compiled Mon 10-Apr-00 13:21 by phanguye Image text-base: 0x80013170, data-base...

When I try to issue the "show dsl ..." command, it says the dsl part is invalid. When I try to ping a remote IP address from the router, it gets no response. When debug dialer is on, it says "cannot place call no dialer string set" each time something like a ping tries to get out of the dsl...

I made the changes that KiscoKid suggested with no success. My configuration looks exactly like the one above and I am getting the same errors with the debug dialer turned on. I also tried using the cable that shipped with the router, and that made no difference. I found this on the Cisco web...

Current configuration: version 12.1 no service pad service timestamps debug uptime service timestamps log uptime no service password-encryption hostname Router enable secret x xxxxxxxxxxxxxxxxxxxxxxxxxxxxx. ip subnet-zero ip name-server xxx.xxx.xxx.xxx ip name-server xxx.xxx.xxx.xxx ip dhcp...

OK, Here's the deal. I had the router up, and I turned on the debug dialer command. I am getting the error: cannot place call no dialer string set. Please help!! It shouldn't need a dialer string!! I'll post the config shortly.

Thank you ChrisAC. I did try to ping a remote ip and did not get an answer, and DNS is not working. I reverted back to the old Westell Modem for now, tomorrow I'm going to attempt this again. I'll let you know how it goes. In the mean time, can someone explain to me what the command "dialer...

I am going tomorrow to use the following configuration on the Cisco 827 ADSL Router with IOS Version 12.1, any suggestions? no service pad service timestamps debug uptime service timestamps log uptime no service password-encryption hostname Router enable secret x...

I've seen the same problem with other routers where the MTU size has to be adjusted. Just something to think about.