Recent content by chattgroup

The route between 172.16.x.x to 10.x.x.x is up and running now. We had to add a route on the watchguard to the ip on the internal router at Site A and everything is good there. Thanks for everyone's help, chattgroup

Okay, when I trace...with the watchguard IP it tries to send me to the outside and Request Times Out With the router IP, it hops no problem What needs to change on the watchguard? A route from 10.x.x.x to Router IP? chattgroup

I do mean "cannot" see the servers etc... I am about to try tracing Thanks, chattgroup

Okay, here is our setup... We have a router to a watchguard (watchguard is our GW) then it breaks down to our network (just like any standard network). This is our main site (172.16.x.x). Inside our network we have a VX Encore CSU/DSU for our remote location to connect through. On data port...

Yes, the default gateway is set on the devices. Another thing that might help is, when try to ping from the (172.16.x.x) network to the (10.x.x.x) I have to change my default gateway on my computer to the ip on the router to be able to ping anything on the 10. side. Any suggestions...

Below is our current config. We are using EIGRP and a PPP encap. ip subnet-zero ! interface Ethernet0 ip address 172.16.x.x 255.255.0.0 no ip directed-broadcast ! interface Serial1 ip address 55.1.0.5 255.255.255.252 no ip directed-broadcast encapsulation ppp no ip mroute-cache no...

Site A - established (172.x.x.x) network Cisco 2620 router MAIN NETWORK (INTERNET, SERVERS, DNS, ETC.) Site B - new install (10.x.x.x) network Cisco 2612 router JUST LINKING TO MAIN SITE T1 connection is established and I can see both the internal and external addresses on the routers yet I...