Recent content by cbd1

Anyone know if there is a way to clear the counters for the sh track command?

Hi, I was hoping you guys could assist me with a VPN question. I was wondering what is the best way to determine that a tunnel has reset due to failed communication with the remote? I usually do: #sh cryp isa sa det, but although this gives me the countdown timer, it doesn't tell me if it was a...

Oh really? I thought, at least at one point, you could take any prof level test including the VP/SP series and it would work to renew your NP as well. So you thought ONT was pretty good? I took the old test in 2006 that still included BCRAN and troubleshooting, so I have never taken ONT at all.

Hi all. My CCNP expires in September of 09 and although I am working on a complete career change, it will be a few years before I am done with the schooling necessary to make the jump. I was wondering if the rules are still that any one professional level exam will renew my NP, and if so, what...

Thanks for the reply. I tried the route to the physical interface. Still reports unroutable. Tried "ip routing" which didn't change anything and it doesn't even show in the config on this ios. IOS=c2600-i-mz.123-12b.bin

Thank you for the reply. I will try to better explain. The device directly connected to the ethernet port via crossover cable is an Airlink Raven. It is an EVDO Internet access device with a single Ethernet port. The device offers 2 options for the internal lan host/s. DHCP, offering a private...

I am hoping someone can give me a clue on where to look next. This is a 2610 connected directly (via crossover) to a cellular internet device. With the device set to offer the public cellular net assigned IP via DHCP, the router works fine. However, with the device set to offer a private IP, the...

Hi, I am hoping someone might be able to help with a small failover issue I am working with. I have a situation where I am using EVDO as a primary data circuit, with a wic1-am for a backup. Currently I am looking for a forgiving fail-over technique. Routing to a tunnel seems like an obvious...

Sorry guys, it was the router. I threw another 2610 on the bench and it worked fine. Thanks anyway!

I am wondering if anyone has seen this problem and how I might resolve it. I am setting up a config for telnet into a DB9 console on another type of device. The device works properly as I can connect to it through hyperterm ANSI 9600N81 and it looks fine. However when I telnet through my 4A/S, I...

YES! Thats what I need... Thank you!!

C'mon guys! :) I know one of you experts can point me in the right direction..

I hope you guys can help me out with this!! I have a situation where I have an ethernet port on my router connected directly to another ethernet port on an adjacent satellite unit via a x-over cable. My static routing is basically this: 0.0.0.0 0.0.0.0 (IP of adjacent satellite unit) 0.0.0.0...

I have a quick question about PVC status on my Cisco routers. It seems that on our AT&T T1 interfaces, the subinterfaces will always show in an "active" state regardless if there is a router connected to the other end of the mapped DLCI. However, on out MCI or Sprint T1s, if there is no router...

Embarrassingly enough, I was under the impression that it was not possible. I’m not really sure why. Heard it somewhere I guess. Anyway, thanks Todd, and sorry for the ridiculous post.