Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by catatung
-
Cisco Router Forgets it's configuration
Hey, The config register was 2142.. Thanks for the suggestion. all is well now. Thanks guys -R -
Cisco Router Forgets it's configuration
whoops, my bad.. There is one 72 pin simm and an 80 pin memory stick.. I looked at a glance and typed before I counted -
Cisco Router Forgets it's configuration
Hey, I have a cisco router, its a 2505. Everytime I configure it, I issue a write memory command from the config mode and when i reload, it forgets its configuration and asks me "would you to enter initial configuration" again.. Is there a battery i can replace? what usually causes... -
Connectivity with a Cisco 2505 Router - ping disappears
I tried to save my config by issuing a Write Memory from the config mode and it says it's building configuration then [OK], but when I reload, I get the same menu driven configuration "would you like to initially configure this router y/n" I'm guessing there is a battery inside I can... -
Connectivity with a Cisco 2505 Router - ping disappears
I configure it from startup with the console. I don't use the serial0 or serial1. From my understanding, this unit is a hub + router, and has an internal hub port connecting the router to it. And i wire my computers directly into the router, as if it were a hub. a piece of my config says... -
Connectivity with a Cisco 2505 Router - ping disappears
Hey, I am trying to put a cisco 2505 into a small isolated network. My configuration is shown at the end of this email: Once I set up this configuration, pings can go through. I am doing it on the initial startup with the menu questions. at this point: Use this configuration? [yes/no]: y... -
Connectivity with a Cisco 2505
Hey, I am trying to put a cisco 2505 into a small isolated network. My configuration is shown at the end of this email: Once I set up this configuration, pings can go through. I am doing it on the initial startup with the menu questions. at this point: Use this configuration? [yes/no]: y...- catatung
- Thread
- Replies: 0
- Forum: Security, hacker detection & forensics
-
simple testing configuration access-list question
ah.. i see it now thanks for the help! -=Randy- catatung
- Post #5
- Forum: Security, hacker detection & forensics
-
simple testing configuration access-list question
Hey thanks I got it working.... How come that command doesn't work though? In theory, shouldn't it?- catatung
- Post #3
- Forum: Security, hacker detection & forensics
-
simple testing configuration access-list question
Hello, I am trying to write up a configuration to test PIX firewalls. I have a pix 515 which I have networked into a hub with two other computers. I am trying to display it's ability to refuse connections. I can ping it from one machine and I can ping the machine from it.. I put in the...- catatung
- Thread
- Replies: 4
- Forum: Security, hacker detection & forensics
