Recent content by camaro67

Thank you KCFLHRC I beleive we have cppm this was done before here but that person is no longer here and I can't find any notes on this, my thought was to lock down the system to only use one core and connect a pc to the inactive core to make changes at that point would i issue the split command...

I need your help again ,I have a CS1000E RLS 5.0 I've been asked if there's a way to make changes to the standby core for testing purposes , I know there's a way to lock down a core so that you have active calls using one core while you make changes to the other, after the changes I will need...

Thank you pmcook one question.... will that work for the CO line or just the internal 4 digit ext? They answer the CO line ? they don't use 4 digit internal dialing

Hello I'm new to IP Office and the issue I have is this, I'm in a tenant environment with each tenant responsible for there own CO lines (loop start pots) and the question i get asked alot is why can't my calls go to voice mail when I'm on the phone. Is there a way to send these calls to the IP...

Very nice ..I am a bit of a fanatic myself too !!

Ok thank you.

Ok.... well there is no PRI at this site and i don't have the packages for a pri . I have 12 copper IN/OUT ground start trunks , If i can't get the Option11 to pass the ext number along we will be forced to upgrade and there looking at Mitel.

Ok I was hoping to be able to send the main number plus the ext# that made the call ...back to the drawing board thanks for your help.

Just so I understand ...it is possible to pass in the caller ID the main number plus the dn that placed the call ?? KCFLHRC What LD would that be done in ??

Does anyone know of a way to have the extension be included in the caller ID to the PSAP ? my extension would equal the room number which would be ok since this is a hotel.Thanks again !!

FYI.......Amcom Software, the leader in mission critical communications software, has acquired Telident 911 Solutions, the successful, enhanced 911 (E911) products of Teltronics, Inc

Thanks for your help I'm looking up Telident now

One of the requirements is to alert the front desk as soon as 911 is dialed and not after the call has been disconnected wouldn't I need to setup the pbx to out pulse the digits as they are being dialed ???

Thank you KCFLHRC but this option 11c doesn't have all the packages needed for OSN so OSN is not an option I was hoping that there was another way to fulfill this requirement, I would even consider a 3rd party gateway if it would work.

I'm working with an old option 11c release 23.55 and before we upgrade I need to find out if there is a way to alert the console that an ext. has dialed 911 I've tried many things so far and I can't seem to come up with a solution that fulfills the requirement... any will be greatly appreciated.