Recent content by btrain8

I am running CM3.1 and I'm trying to putz around with service observing. in 'disp sys-para cust' the basic service observing feature is flagged to yes. I've put the button on my phone for which I have console permissions and when I press it I get wave off. What else needs to be set for this?

Are the 2 systems linked with an IP trunk or are they completely seperate?

How do I know what rule is being used. I did a display on rule 1 and rule 2 and there's no mention of what is using what and I haven't checked to see if any others are assigned.

Is that done on the main or the lsp site?

When doing a 'list ars ana' the entries appear but the route pattern fields have Px (x=#) which I know are partition route patterns. How do I follow this to find out exactly what these dialed digits are doing and see the actual route patterns?? When I do 'list partition-route-table' I see...

after an lsp takes over as a standalone.. once the link back to the main server comes back up.. how do you go back to lsp mode?

What can possibly be the cause if 1 user.. 1.. calls his assistant from his bberry (non pbx #)and the call goes directly to her VM but nobody else that calls this person has this issue? There's no EC500, no fwd'ng turned on so this makes no sense.

Avaya said on the 2.0 switch that an upgrade would be required to 2.2 and then the patch can be applied. We will be upgrading all our switches and LSP'ng them in the 2nd quarter so we aren't going to do this. It's been this way for quite some time. Avaya indicated that we should wait until...

1 site is: R013x.00.1.346.0 the other is: R12x.00.1.221.1

S8300 -- cm 2.0 and S8300 cm 3.0 both are not DST patched, hence why we need to manually do this during this time period.

I have a few older switches that uses CM2.0 that do not have the patch so we have to remove our NTS IP addresses for a few weeks and go to local clock until this weekend. When I put back the IP addresses the clocks went back an hour. How does this happen.. all my other switches that use this...

Yea but I have to do over 100 numbers.. incoming call handling treatment looks like it can only store 64.

I know you can have DNIS with toll free numbers, but can a carrier send down DNIS on DID's?? ex.. DID range 203-324-9500 -- 203-324-9599 can the carrier, when someone calls any of those numbers send down a 4 digit DNIS such as 2111 instead of the 95xx??

For a cm 2.2 switch.. what is the limit of entries into the trunk group for incoming call handling treatment.. is it 64 max??

Just got 1 of these to mess around and test with and I'm unable to get power. I used a standard power supply that I had from my 9630's as I have no POE switches. I've messed with the dip switch in the back and nothing. Any ideas on what this phone needs for power?