Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by brison

  1. brison

    OPX card test

    Trying to test an OPX card NT1R20BA. Programmed as an analog card and it shows on terminal as such. Should I be able to attach an analog phone locally and receive dial tone?
  2. brison

    Teltronics SEB console access

    I tried with and without null modem / modem eliminator. I don't know how to tell if ports are disabled. My aim is to assess the health of the units and confirm memory, port count, etc.
  3. brison

    Teltronics SEB console access

    Trying to get an SEB2 (not NetPath) to talk to me via Procomm+. Used both local and host1 interfaces. All baud rates 8-N-1 with and without modem eliminator. Procomm shows connected but no data whatsoever and no response to CR or any other keys. Tried multiple units with no luck. Anyone...
  4. brison

    CS1000 2921 install file

    Getting BUG7385 or BUG7388 when trying to boot from floppy....deleted and recopied the diskos to no avail.
  5. brison

    CS1000 2921 install file

    Thanks, Firebird. Great site. I copied the zip file to a floppy. Before I start beating my head against the wall (or not), do you know if there is a filename sequence CS1000M wants to see to install or will it search the folders as-is?
  6. brison

    CS1000 2921 install file

    Does anyone have disk2921.sys ? Trying to load an old 3.0 for testing IODUC Thanks Brison
  7. brison

    Cannot transfer

    F985 = 333 not sure on the number of intercom buttons - would that restrict ability to xfer? previous comment was that the stations in question cannot transfer calls at all and I verified by attempting xfer to receptionist. Sorry for confusion
  8. brison

    Cannot transfer

    Stations in question cannot tranfer to any other stations - tested trying to xfer to receptionist. Callers not disconnected, just left with dead air until they hang up. No error given on display.
  9. brison

    Cannot transfer

    Good questions - DND was my first thought, but then they wouldn't be able to intercom each other. No error is shown or tone given. When Xfer is initiated from one of the stations to the other, the call disappears. I have not tried xfer from one of the stations to 221, yet. Stations have been in...
  10. brison

    Cannot transfer

    7208/7310
  11. brison

    Cannot transfer

    We have a customer that cannot transfer calls from stations 226 and 250 to stations 225 and 251. This system was set up long ago - pretty large MICS. The phones are in 2 separate suites. The main receptionist can transfer calls to these stations. These stations can intercom each other. Is...
  12. brison

    Replace G700 expansion cabinet

    Can we replace a G700 expansion cabinet without reprogramming the system? Is there a procedure that someone can point me to (assuming it's more than power down and physically replace)?
  13. brison

    Circuit pack status

    You are correct - test and status both work. Thank you.
  14. brison

    Circuit pack status

    Thanks kyle555. GEDI throws "board" as an invalid entry.
  15. brison

    Circuit pack status

    Is there a way to get status on a digital station circuit pack in ASA? I'm remote so I cannot see the indicators on the card.
See more

Part and Inventory Search

Back
Top