Recent content by brendangriffin

You will need to create a packet filter to allow web access from the actual ISA server itself to allow it web access.

What address range are you using for your internal network?

Can you not just change the ports that IIS uses?

Thanks a lot for your help

Hi, Please forgive me for my lack of knowledge before I start.... I have a scanrio whereby I need to replace a server, I am happy backing up and restoring the databases between the two servers using the SQL utiliyu but what I need to know is if things such as stored procedures/triggers that...

Hi, This is a problem with permissions, you need to ensure that the user has permissions to write to the report file, if you installed VSCAN as administrator this would explain the problem. I have had this issue with several W2k/XP machines. Brendan

Hi, I need to schedule a batch file to run isng the W2k task scheduler service, i have attempted to do this via system tools but it tells me that the service isn't running. I then checked out the services and task scheduler is not listed? even though mstask.exe (the actual .exe that the...

Hi, I'm quite new to linux and i'm looking to setup a test server to act as a firewall/proxy server. Are there any packages that you could recommend me to acheive this. Thanks Brendan

Hi, Am I right in thinking that all I need to do on the ISA server is to create a packet filter to allow port 25 plus the relevant DNS query ports? When you say local Address Table do you meant the LAt in ISA Server? Thanks for you help Brendan

Hi, I am looking at setting up my SBS server with external email. I propose to put in a second network card with an external IP address and my ISP will forward all SMTP mail to this external address. The question that I have is are there any changes that I will need to make to Exchange/ISA...

Hi, I need to enable outbound VPN access to a PPTP VPN server. I have enabled ports 1723 and 47 but neither the server or clients can connect. I receiver RAS error message 721. It seems to fall over when verifying username and password do you have any ideas at all. Thanks Brendan

Hi, I have a problem whereby a user sends a print, and if this fails for any reason e.g. the printer is switched off. Another user receives the error msg 0782-057, should only the user that sends the print receive the error msg? or can this be setup so that only certain users receive this msg...

Hi, Could you not just set up two static routes? e.g. one for the 192 network and once for the 10 network. route add -p 10.0.8.0 mask 255.255.255.0 192.168.0.1 route add -p 192.168.0.0 mask 255.255.255.0 10.0.8.200 I'm not sure if this is correct but you could give it a try?

Hi, If you go into User manager for dmains from admin tools. Then select the user you wish to grant permission too, click dial-in and then you can select to give the user dial in permission. I think thats what you asked for!

Hi, I have a problem at the moment we have a printer setup on a jet direct and occasionally the configuration of the printer changes from LPR to RAW this is causing us lots of problems. Have any one you ever seen anything like this before??? Thanks in advance Brendan