Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by brccd

  1. brccd

    Music-on-hold

    I had found that the connection was not being made and also cut back the plug cover a bit. If i use an output from a standard cd player though (headphone output), the music on hold is still very low. Even though volume on the cd unit is turned up and on the avaya system it is set to max. Are...
  2. brccd

    Music-on-hold

    I also have an issue with the music on hold as well.... I am using an avaya ACS 7 system, and would like to use a regular mp3 player headphone output to the music jack. I have tried this but the music is really low and and volumes are up everywhere. I look at the spec and it says the jack...
  3. brccd

    ACS R7 and 308EC Line Numbering/slot

    ok...ok... for ttech, I did see those lines of instruction, but I read it differently... "4. In the other slots, from left to right, first install the T1 or 1600 DSL module, then the 012E, 308E, or 206 modules, folled by the 400 or 200 modules and/or a Partner Messaging or PARTNER MAIL VS...
  4. brccd

    ACS R7 and 308EC Line Numbering/slot

    I did look through all of the documentation, and there is nowhere that states how the slots will define lines for the 308. There is one picture that shows a 308 to the left of the proc, and its slot 2, and shows lines defined as 22,23,24! I am not sure if that is correct either, but it didn't...
  5. brccd

    ACS R7 and 308EC Line Numbering/slot

    Well, I put the 308 in slot 1, set the phones to see lines there as 6,7,8...and it WORKED!!! Weee. Boy, the avaya documentation is not very good at all in describing this configuration, NOT----AT-----ALL! Lots of guessing work with this box! But, at least once you get it, it does seem to work...
  6. brccd

    ACS R7 and 308EC Line Numbering/slot

    OK, so if say I were to leave the 308 card in slot 2, then the lines should look like 9,10,11...is that right? or, do you need to have it really start from the first slot? That is, do you have to fill the 5 slot carrier from the left most slot first? Thanks bert
  7. brccd

    ACS R7 and 308EC Line Numbering/slot

    Hi, Another confused person re documentation. I have a 5 lot carrier with Partner ACS Release 7.0 Control Unit (5x9). I am having a problem, probably configuration...i have 6 lines, and am using 5 going into the controller. First 5 work correctly. The 6th, i am using on the 308 module. Having...
See more

Part and Inventory Search

Back
Top