Recent content by bradcarter

Hi, I'm very new to ARCserve. The only backups I've done before is using rsync so I'm confused on how to set up a backup scheme with ARCserve. Our corporation has required that once a week we send off backup tapes for off site storage. I'd like to start a full backup on Tuesday 12am and...

I purchased a couple Cisco routers from eBay in order to learn Cisco routing. I have a question regarding the use of the VIC-2E&M cards. Can I set up 2 routers with the VIC-2E&M in each one and pass audio over the WAN side of the routers? I'm looking for a point to point audio channel that's...

I'm in a situation with a G3V6i where we can call into a station and then transfer that call off premises. Works fine. My problem is when we call out on a station and then try to transfer that call, after the transfer button is press the second time to release the call it never does. Any...

Sorry, I'm not the best with PBXs. Ours got handed to me when another employee quit so everything I've learned is been the way of trying different things on the PBX as we need them. List Trace Station doesn't work. After List Trace, Station doesn't show up in the list of available commands...

We are getting about 20 calls an hour to the Attd console that have no one on the other end of the line. The calls are showing up on the console as "Incoming to Operator - ic". Most normal calls into our building show up as "Incoming to ABCD - Id" where ABCD is our company name. Our trunk...

Phanman123, This is exactly what I thought. My 2 Multitech modems can connect with each other with a simple RJ11 cable between them. I figured I could put one of these modems at each end of the OPX circuit and have it work but it didn't. I had my coworker at the other end of the circuit and...

Hi guys, we have an off premises extension hooked up to our Definity PBX. The original purpose for this extension was voice but now we are using it for a modem-to-modem connection. I bought a couple 2-wire leased line modems hoping to bypass the PBX and use the line provided by the telco. The...

I ran into a simular problem, I ordered more DIDs from Qwest and they assigned them to 8100-8119. After the order and assigmnet I realised that digit 8 was assigned DAC. # and * were set for 2 digits of FAC so I didn't have room to move the digit 8 DACs to the # and * series. I had to delete...

Hi guys, I would like to start off by thanking everyone for taking time to post to this forum. It's a great resource. We are running G3Si V6 and I would like to create an intercom group that will join more then one person at the same time. I basically want group paging but 2 way I know how...