Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Bobtheicon

  1. Bobtheicon

    3300 MXe MiVB 8.0 - No Audio over Wireless Bridge

    Thanks for the reply. Good thoughts -- I'll check out and disable CDP and see what happens. Others have suggested subnetting Building B and putting in a Default Gateway; which is fine but I'd sure like to know why it doesn't work as configured. And that part about one phone works and if you plug...
  2. Bobtheicon

    3300 MXe MiVB 8.0 - No Audio over Wireless Bridge

    Here's a crazy one. Flat voice network on VLAN 40 (192.168.100.X/24). MXe NIC connected to Cisco Small Business SG350 untagged VLAN 40 port. Cisco switch also some some data VLANs on it (all untagged). It has a VLAN trunk port (all VLANs tagged) going to a Ubiquity Nanobeam set up in a...
  3. Bobtheicon

    200ICP - sending Caller ID on T1

    Thanks for the info. This is my first regular T1 - I have done a few PRIs and prefer them. I have a pretty good handle on IMAT too. So it looks like I'm stuck sending out the main number as my caller ID if I can't use the *6 in form 22... Probably not that big a deal anyway, just thought it...
  4. Bobtheicon

    200ICP - sending Caller ID on T1

    I'm sorry - Its been a long day... The T1 is connected to the Dual Framer T1/E1 card in MMC 1. It looks like I can use Form 22 to accomplish this. But I wonder if I can still send the main number for extensions that do not have DID numbers.
  5. Bobtheicon

    200ICP - sending Caller ID on T1

    200ICP with 2Way DID T1 trunking. All calls that go out display the main number (the first assigned DID number). No big deal, except the fax is a different DID number than the main number. I know I can send whatever I want with an NSU using the modified digit table; but would that be the same...
  6. Bobtheicon

    911 via Abbreviated Dial

    Thanks everyone, I appreciate the input. I think I am going to have the "emergency" button dial 0, but also label the phones "for emergency, dial 911". Then I'll take MitelInMyBlood's advice and setup ARS accordingly -- Great idea by the way!! Thanks again, Bob
  7. Bobtheicon

    911 via Abbreviated Dial

    Installing an SX-200ICP in a large hotel. Thinking about programming all of the room phones' speed dial buttons with abbreviated dial codes (*10, *11, *12, *13, *14, etc.). That way, room phone programming is simple (analog room phones) and I can easily change what each button does. The...
See more

Part and Inventory Search

Back
Top