Recent content by boalturas

It might be just I didn't understand the term "renumber". It looked to me it is to logically move the slot/board number? But from other part it appears "renumber" is just to get the processor board to know what boards are there, correct?

5)In System Programming, do a Board Renumber What does this step do? It is necessary to move the new board to a lower number?

We have the following: Cabinet 1 0: Processor CKE5 1: 412 LS-TDL 2: 024 TDL 3: 016 TRR 4: 800 GL-ID 5: 800 DID Cabinet 2 6: Merlin Messaging Have never done adding boards. Do I just: 1) power all down 2) insert 024TDL to slot 7 3) power on 4) new board is recognized? 5) go renumber the 24 new...

Hi Thanks TTT. That worked for me. The dialer is mainly for some temperature sensor, not life threatening stuff so it is OK.

I clicked buttons 1 all the way to 20. 1: Ext Ring -I 2: Ext Ring -I 3: Line 801 -I 4: Line 802 -I 5: Line 803 -I All others are blank. It seems we don't a pool setup? I looked it over in "Quick Access" > Calling Groups > Lines & Pools tab (outside standard SPM). Did not find anything about...

Hi TTT, I got to the point before "press pool button": I don't know which one is pool button. The SPM screen is not the same as 4424LD+. The middle block has 5 buttons in a column on SPM but the phone has 6 buttons in each column. Also I checked manual found *35 is for "No ring" option. Not...

Hi TTT, I was able to do the first part in standard SPM. I don't know where to do "Centralized Telephone Programming". Is it on the 4424LD+ ?

And we have 3 outside lines 801 802 and 803. I don't know about pool 70.

System Program Start Extensions Lines Extension Number and Enter Entry Mode 801 Enter (if 801 is a part of Pool 70, that's all you have to assign to get a Pool Button that represents the entire pool) Is above to be done with WinSPM or Stardard SPM (which you launch from within WInSPM)? Then in...

We have a 016 T/R board. Several analog phones are on those ports. Some of them needs to dial 9 to get outside line some get outside when they go off hook (w/o 9). How do I change the ones that require 9 such that they would get outside line by going off hook? I have working winspm but I am not...

Still don't understand why auth code and forward statuses are still off, although it is working now (see red lines below). It is just a very screwy system but I don't care. Thanks again TTT. Extn SS/PP Type 110 2/ 1 4412D+ CTI Link : No Alarms: ACTIVE...

Thanks. Adding 9 made it work for calls initiated from another extension. Did not work for outside calls transferred to that extension. So I did #80 to enter the auth code at the actual phone (although it has been said it is not needed), then it worked for outside calls.

@TTT it is in key mode. at the startup screen of standard SPM, bottom, it says "NAGIX Release 1.5 v6.0 Mode: Key".

to TTT, I don't know what "Key Mode" is. Regularly we don't dial 9 to get outside access. Just get off hook we have outside dial tone, and just dial the outside numbers. For internal calls to other extensions, we hit SA button then get off hook to get inside dial tone, and dial the other...

on 3. I did: in SPM: sys program >> LineTrunks >> TT/LS Disc >> LS disconnect >> LS Reliable Disconnecting: Select One Yes is already red. I selected Yes again anyway and Enter, Back all the way out. Still the same.