Hello,
I recently changed printers and when I select the hp printer under output all of my options for screening are greyed out. Even trying to select a ppd is greyed out. I would appreciate any tips on how to be able to select the screening.
Hi All,
I've used 3d studio for years and want to put my interior models into quicktime vr. I don't know where to start (Obviously I need to get QTVR Authoring Studio) but could someone lead me in the right steps. IE: is there a camera plug in that shoots the proper images in 3d studio to bring...
That did it. Also after doing some research with hp, It mentions that 10.3 doesn't remember the printer and that's why I have to do that.
Again...thanks so much for the help!!!!!
Blind Lemon
Jimoblak,
Thanks for the quick response. I'm assuming your speaking in terms of PC. I should have mentioned I'm on a Mac..OSX. Being fairly new to OSX, do you have any idea where I would find a setup button that you mentioned in the Mac world.
Thanks again
Blind Lemon
Hello,
A document I created in pagemaker would print within 3/16" of the edge of the page. After importing the same document into InDesign and printing on the same printer, it's cropping 1/2" off all edges of the page. Where are settings where I can get back to 3/16". I know the printer will do...
Hello,
I downloaded a plant where a leaf image is mapped the same way to each individual leaf of the model. How is this achieved? If I use uvw map and use any of the methods, it spreads the image out over the entire area, not the individual leaves.
Thanks
Blindlemon
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.