Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by bkrike

  1. bkrike

    MICS/Call Pilot/.....Setting up Private DID for operator position

    Every line is in the default group 1 by default. That's why it is easy to set up night ringing. You dont have to input the lines.. You only have to input the set as the VM-DN. The lines are already there, which is why when he sets up her new DID, it is answered by the AA (since services are on...
  2. bkrike

    MICS/Call Pilot/.....Setting up Private DID for operator position

    I read your post one more time. You dont mention if she has a voice mail box currently, or if this is a "new" mbx that needs to be separate from one she already has. My previous solution would send the new DID to her current mbx (assuming she has one,) but she could have a "private line". For...
  3. bkrike

    MICS/Call Pilot/.....Setting up Private DID for operator position

    When you assign her this new DID, have you taken that target line out of the control group that every other line is in by default, which is how the services probably work now? So if 7251 is the set where the services are turned on and off at, then 7251 is most likely the control set for all the...
  4. bkrike

    Calls going directly to General Delivery MB?

    what about DND on Busy.- Is that being used by any of the reception phones, that might overflow to VM.
  5. bkrike

    CP-150 CCR tree reports?

    The CCR report will show the number of times each node was visited in the last 7 days. It only saves the data for the previous 7 days, so they would have to collect weekly. It is all covered extensively in the manual.
  6. bkrike

    Calls going directly to General Delivery MB?

    The channels being busy would not cause the gen deliv to pick up, as the gen deliv needs a channel in order to answer. You need to check your settings; particularly any CFWD on busy. If you have a CFWD on busy, just disable it, as it is not needed.
  7. bkrike

    T1 to E1?

    sorry Hawks- I would love to give you some answer, but I don’t know a thing about UK stuff. From the UK posts I have read in this forum, I would agree with Biv, in that the software is definitely different. I have noticed UK even has a different software release numbering system.
  8. bkrike

    New Norstar cics installation

    I can’t tell from your post if you are planning on trying to install this yourself or not. If you are, then plan on being down indefinitely. The instructions are no meant for end-users. If you want minimal down time, get a with a qualified Nortel vendor. Have them do a pre-install site survey...
  9. bkrike

    Getting out of vm

    Depends if return to AA is enabled. You can try *.
  10. bkrike

    Loud Bell

    Yes. A qualified Nortel vendor would be able to connect and configure a loud bell to ring for you at the same time as the 7310.
  11. bkrike

    Itercom buttons with a line assingment?

    1. Add intercoms under T&S 2. Add line "appearances" of the target in question.
  12. bkrike

    Norstar 6.1 with PRI DID- Night Service

    yes- clearing the control will fix it, and yes two tenants can have separate night keys. With the night keys, when you set up 2 services, f871 allows you to scroll through the named services until you find the one you want.
  13. bkrike

    RJ45's cat5 vs cat6

    Just joking around above crooter- Anyhow, as the people above have answered: Yes, there are differences between the cat5e and cat6 "plastic end that 8 wires fit into and then has to be crimped.
  14. bkrike

    RJ45's cat5 vs cat6

    stop the madness the answer is YES
  15. bkrike

    MICS Keycodes

    The t1 card goes in slot 4 if it is your first card (lines 1-23)
See more

Part and Inventory Search

Back
Top