In doing a DR restore, we have a support partition on our servers (C:\) and a system or production partition (D:\)
we start the support partition (or create a new one) and run the client to restore the prod (d:\) partition from backup, but when we select the System state restore, it always...
ptiernan - im having the exact same issue and the KB article didnt help much either.
do you have info on that fix you did to remove the errors handy?
Thanks!
hehe..a little late, but here are the two direct links for v7 sp2 and v7 sp2 update
update:
http://h18000.www1.hp.com/products/servers/management/sp23545.exe
full:
http://h18000.www1.hp.com/products/servers/management/sp24904.exe
anyone seen or use these still? what exactly is thier purpose? I have 2, one on my MOH, and on my Paging. anyone know the pin outs? they both connect to a 66 block with a mess of wires and jumpers and that is not my style, i want to clean it up a bit.
Thanks -
BillyZ
I know its been a while, but i wanted to close this out -- To fix the problem, I re-flashed the PIX (actually there was an update available, so now it works OK, all can ping all)
-BIllyZ
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.