Recent content by BeavisLee

I was able to setup two ethernet attached 1760's to handle calls from one to the other. One unit has 2 FXS ports and the other 2 E&M. I have anolog phones connected to the FXS ports and the E&M ports go to a PBX. Both sides could make and receive calls both from one port on one router to the...

I have followed the instructions to the letter and it works ... kinda. I dial in enter the code and dial out however after I hang up the backdoor line remains "in use" for a long time .. 3-5 minutes! Thought it might have been a dodgy trunk card so I ordered a new one but same thing happens...

Is there a way to program a global speed dial that includes Feature 68 and an access code? I want all users to be able to call our remote offices but don't want them to have access to the 6 digit code to make outside calls for security and convienence. Thanks.

MRoberts, Thanks bunches for that set of instructions. Can't wait to give it a try. Just to be sure ... I connect this back door line to a regular LS/DS trunk port correct?

Thanks much for the help thus far folks .. I have an unused E&M card in the system, how do i go about programming it to ake this work?

This is the situation. I would like to have our directors dial our head office from their cell phone or home, grab a trunk that has overseas access and call out so these calls would be billed to the company. Is this possible on this system? Thanks for the quick reply!

Is is possible to configure off premise calling on this system/software release? If it is, do I need any special hardware and what is required to configure it? Thanks! Kevin