Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by bdlamprecht

  1. bdlamprecht

    Cisco 877 Unnumbered

    You very well may be right. I don't know how to use the unnumbered feature or if that is even what I am looking for. I may try and play with it some more, but if you have any more ideas or hints you could give me that would be helpful. Thanks.
  2. bdlamprecht

    Cisco 877 Unnumbered

    I know that using NAT would make this a whole lot easier, but I need to use public IPs on my internal network. There is no way around this. I'm stuck and might have to call somebody and pay $$$ for the support. We shall see. Any further ideas?
  3. bdlamprecht

    Cisco 877 Unnumbered

    I know I could assign the VLAN1 interface an IP address, but by doing I "lose" 1 usable address given to me by the ISP. I have a /29 or 255.255.255.248 subnet mask which gives me 6 usable addresses. 1 is for the Dialer0 interface to act as the gateway for the remaining 5. If I assign the...
  4. bdlamprecht

    Cisco 877 Unnumbered

    The "dialer-list 1 protocol ip permit" should allow all ip traffic to go across the dialer and atm interfaces. I know if you want to use NAT you have to implcitly allow want you want in an ACL, but I don't think that is the case here. I don't want to use NAT or DHCP. I believe I need to find...
  5. bdlamprecht

    Cisco 877 Unnumbered

    Note: The interface atm0 is shutdown in the above config, but when that is enabled, the problem still exists.
  6. bdlamprecht

    Cisco 877 Unnumbered

    I am trying to setup an 877 router in unnumbered mode and cannot seem to find what I am doing wrong. From the router console I can ping the outside world fine, but on the LAN side, nothing gets through, not even to the IP address of the dialer0 interface. Here is my config if anyone can help...
See more

Part and Inventory Search

Back
Top