Recent content by Avstral

megglesfield, You may fing all the instructions in ALEX under INSTALLATION INSTRUCTIONS for DBC 425. In short (copy/paste) 1.The Phone Contacts are stored on an FTP server located on the same server as used for software server. The stored file will be loaded from the FTP server when the...

That was a tromboning patch in BC9: /* ASSEMBLY SOLUTION : */ PCASI:UNIT=RMPS5,CI=C67990A,REV=1-R9A,IA=1DA6,RA=1DC4; END; !A...

taurus2711, Upgrade procedure above is correct. But forget about BC12. Upgrade directly to "MX-ONE Telephony System – Telephony Switch". This is new name of MD110. You can consider it as MD110 BC13. BC12 will be in passive sustaining in 5-6 month and SP11 will be the last update. If you...

Daddy, Looks like there is nothing about "idle/busy" in SP10 slogan. hdemir, In SP7 we had massive problems with "idle/busy" on ISDN (AU application). Getting better after upgrade to SP9. In any case, you know first rule - upgrade to latest SP - SP10. Yes, I know this will be pain in your...

Hi Tom, Thanks for share this! To add a bit of history. Year 1976. In Ellemetel (company formed by Televerket&Ericsson), the sides could not rich an agreement about size of the system - is it to be smaller or larger :) And while specs changed few times, it was born an idea that satisfied...

Check FAQ page. Correction for BC10 is there for the last 4 years... Regards

nccoi, You don't really need a PROGRAM here. Hex value below BPOS in the table is your multno for respective equ. Regards ________________________________________________________________________________________ BPOS 0-00 BPOS 0-40...

The answer is YES, you can. No limitation for ROF 131 954/2 ROF 131 954/3 ROF 131 954/4 with any R-state. Regards

pawshman, As it was already noted in the above-mentioned link, for BC12 you DON'T NEED ANY TROMBONEENG patch!!!! Just use ASPAC 118 - "Loop back avoidance check selection" Regards

Dutch, Reset NIU manually and try again. I did this myself and insist- this works. Regards

Tested and works: R13->R10 R16->R12 R12->R10 R13->R10 R14->R13 ALL OK Not OK: R16->R10 R14->R10 R14->R12 Regards

There were no problems with HDU2&HDU3 in BC6&7. But in was not possible to use more than 255 Mbytes on HDU 6&7. That was because IPP unit used 8 bit variable to store HDU size. To override it, IPU must be at least R15A and are to load up 2 corrections in BC7.1: S48663A U45984A If you need...

jinjin, Put in your e-mail. Regards

jinjin, Shop around for second hand card. I know at least one company in my country able to deliver QDLU board. Regards

For sure, there is. Latest is SAM 3.7 SP3 updated on 2004-12-17 (Updated files for PC-Regen) Too big to sent via e-mail. About 32 meg. Regards