Recent content by ashari1

Does anyone have a filter built or know how to build a filter for unicast traffic.I have a switchport on a cisco 6500 that has very little traffic,but the unicast counters contiue to increase.

Thanks rwullems, I didn't think that this card was supported.I was just hoping that someone might have found one.If anyone should know it should be you.

Does anyone know if there is a driver for the Linksys 54g notebook adapter,that will work with NAI Sniffer Pro 4.7.5 or Network Instruments Observer 8. I am trying to do some captures.The only traffic I see is traffic that is destined for my adapter.The card does not seem to be in promiscuous mode.

The command to view the cam table(MAC Address Table)on a Cisco IOS switch is:sh mac-address-table.This should show all the MAC's that the switch has seen within the cam aging time.The default is 300 sec.If you want to check the MAC address of a device in a particular port the command is:sh...

This may sound silly but did you check that the port speed on the switch is not set to 100mbps/full duplex and the NIC at 10mbps/half duplex.This will cause the two devices to show a link light but not pass data.It is important that the NIC matches the speed and duplex of the...

Eistee, I should have said you will not be able to connect on any vlan that is not defined on both interfaces.

Eistee, have you checked that the vlans are allowed on the Core Switches(6500)and the access switches(2950).In the configuration of the 2950 under interface VLAN 1 and on the 6500 on the uplink port(allowed vlans).If the vlan data on both uplink ports do not mathch you can not make a...