Recent content by Anita21

Hi I just upgraded Ross prom 2.22R in my ss20 (MP) When monitoring in Solaris Management Console the status of cpu (two cpu installed), I get: --cpu 0 75mzh clock speed (this is fine) --cpu 2 16,xxx,xxx mzh clock speed (this is err) Both cpu are 75mzh. Command---module-info --reports correct...

Thanks for your response ady2k, I agree with you, while going through threads I have realised that CCNA can be done before entring solaris but for SCNA the requirement is to be SCSA so when I qualify for the requirement than I should first go for SCNA. Regards, Anita anita21@optusnet.com.au

Thanks for your response fsjcp2, I agree with you, while going through threads I have realised that CCNA can be done before entring solaris but for SCNA the requirement is to be SCSA so when I qualify for the requirement than I should first go for SCNA. Regards, Anita anita21@optusnet.com.au

Hi, Can someone please advise which course would be better for me to do "SCNA or CCNA" after doing my SCSA.

Hi, Can someone please advise me that which course "SCNA OR CCNA" would be better to do after being a SCSA. Regards, Anita anita21@optusnet.com.au

Thanks Zoufri75, you are more than helpful. Regards, Anita

Thanks mrn your advice has been helpful, and thanks to you williambishop as well the thing is I am one of those who know how to use google but I never typed solarisboard on google, boy that works. well there are some questions I could find in webmaster as follows, anyone with anymore...

Hi, I would be going for Part II certification exam in a week's time, has anyone got any braindumps or links for practice exams. Regards, Anita

Hi, I would be going for Part II certification exam in a weeks time, can anyone please help me in finding some practice test questions. Regards, Anita

Hi grepme, I am going for part II exam in a weeks time, as you mentioned that a lot of stuff is asked about NIS+, I am a bit concerned, as NIS+ is not mentioned in syllabus. How deep do you think they go in NIS+??

Has anyone got any suggestions?????

Thanks for the suggestions jamisar, but I guess that the HDD is faulty as it does not spin (even though it is brand new and came in anti-static packing), the SCA pins are bent are touching each other or could be broken so it does not even recognise the drive. Regds, Anita

Hi, When I boot a SPARCserver 20 MP after a overnight shutdown, it goes into diagnostic mode (diag-switch? set to true automatically) and it tries to boot from net. After doing diag-switch = false and reset and shutdown and then reboot it boots okay. It shows the date and time of the last...

Yes, I did probe-scsi and probe-scsi-all but, it only shows the boot disk, which is at target 3 Regds, Anita

Trying to install DPSS-309170 80PIN 9.1 GB in SS20. No jumper setting is done, boot -r gives error: 1. Error for command load/start/stop 2. Sense key: Not ready 3. LUN not ready devfsadm picks up the drive (second disk, so it is c0t1d0). Format gives drive type unknown, IBM says format.dat...