Recent content by anilsiri

HI, I have NS-50 and NS-100 talking to each other using a VPN. I have made use of Untrust Interface IPs as remote gateway IPs for VPN to work. NS-50 Untrust is connected to 196.12.32.0/24 and NS-100 is Untrust connected to 209.247.163.0/24. Now I want to run a parallel VPN between same...

HI, Is there any way to redistribute via ospf, routes with distance other than default value 110? Thanks, Anil

I enabled debug h323 all option on Netscreen-50 and tried to connect to otherend video conf box and I could see the following in "get dbuf stream" ## 02:07:07 : Q931 cookie id 128 ## 02:07:07 : Error!!! - (Unknown H.323 Packet) ## 02:07:07 : Error - Invalid packet - dropped. ## 02:07:07 ...

Thanks John.

Hi, We have Netscreen-50 at our end and NS-100 at US end. Our Internal networks connect via VPN configured on Netscreen. We have polycom Viewstation Video conference equipment behind the firewalls at both ends. Video conference was working fine between the two sites, but recently when we...

Hi, We have Netscreen-50 in India Office and Netscreen-100 at US office running VPN between them. This VPN passes through our IPLC circuit. Recently we took an Internet circuit in India. Our plan is to make this Internet ckt primary between offices as it has more BW and less latency and IPLC as...

Thanks. But the routers between LA and NYC run iBGP also.

Hi, I have a network with 512K dedicated circuit on fiber to LA, 256K dedicated ciruit on satellite to NYC and 1Mb shared internet on fiber. 512K and Internet circuits are on 2620 router and 256K ckt on 2500 router. I'm running OSPF on both the routers and HSRP to make 2620 the active router...

Thanks Tschouten, I have to load balance only two Unix servers. Will it work? Thanks, Anil

Hi all, I have cisco 3640 Router and want to enable server load balancing using "ip slb vserver". Will the Router support this? I am able to see the options in the configuration mode. But does it overload the Router? Thanks, Anil

Hi, I have two servers which should act as backup for each other. One will be active and the other will be passive and should take over as soon as active server goes down. My question is "Can this failover be achieved using Cisco Routers?" Is there any concept of IP Failover or...

Hi, Are the Summit48i Extreme switches Layer-3 switches? Please suggest. Anil

Hi, I have a 3548XL switch as spare and found some problem in it. When it is powered on all the LEDs on its ports are glowing constantly and when connecting through CONSOLE its giving out junk characters on terminal. Is the switch bad? Please suggest.. Anil

Hai, I have Summit48 extreme switches and want to cascade them with 3548XL cisco switches. Is this possible? How can I achieve this? Please anyone suggest ... Anil

I am looking for a free traffic analysis tool which can give me the details of the TOP 10 users in my network at any specified interval mostly in a graphical way. Is there any software available? Anil