Recent content by almostretired

Cotton might work though it would have to be taped in place as there is no real "hole" at the transmitter to try to stuff. Also, it can't be bulky or the phone won't sit in the charger. I had tried earlier with packing case foam.

I have a customer whose T7406 phone finally gave up the ghost. I replaced it with a T7406e which now works almost too well. It is in a noisy location in a printing shop and the PA system is quite loud so employees can hear over the constant noise. I tried adjusting the "noisy location" settings...

I was back at the site today. The CP is release 01 and the CICS is 2.0. I have tried using different ports on the CICS for the CP and also tried removing the F98- feature codes and then re-booting. Still has the CP taking the B2 DN which cannot be input for Call Forward No Answer. If I point it...

I believe it's 6.0. I'll verify that tomorrow

I just installed a CP 100 Ver 2.0 on an existing CICS. Everything works fine except cannot forward calls to the CP on a Rings DA. F985 brings up the B2 DN instead of the B1 DN and I can not forward calls No Answer. I have tried changing the CICS ports the CP is on and F985 always brings up the...

Both the old and the new Power Supplys appear to be good at 8V output.

I have a CallPilot 150 with 3.1 software connected to An MICS running 6.1 software that has been working for 1 year and 5 days (who's counting).That's the last time I had to replace this one due to a power hit. At that time a UPS was installed. I was told F981 just returned "Inactive Feature"...

My customer has a CICS running 4.2 s/w WI6.0. The trouble has occurred on at least 2 different sets calling different numbers. They establish the call then put it on hold to get information or whatever and the Flashing indicator is not operating when they return so they think the call has...

There are several reasons I'd rather not do a startup, not the least of which is the aggravation to the customer. Curly - being almost retired means I get to pick and choose the jobs I want which is very satisfying.

Strange one today. Had to remove a Trunk module and 2 port Fibre expansion from an MICS running 6.1. They'd been installed in error - Sales!!! I powered down, removed the expansion card and powered up again. All sets came up saying "In Maintenance" and the customer was out of service. After 10...

Thanks for the confirmation. You're right, the price for a bundle is pretty reasonable.

I have a customer wanting to upgrade from a StarTalk Mini to a CP100. Presently they have a 616 DR5 DS. I know CP100 will work on a 3x8 DR 5.1. Is there a 5.1 DS software for the 616 and has anybody had any first hand experience getting one to work? Thanks in advance

I have an MICS customer running 4.1XC WI6.15 and PRI. If a call comes in on his DID while his set is forwarded, there is a 4 or 5 second delay and then an "all trunks busy". I have verified there are lots of free channels on the PRI and tried just an internal extension to extension call which...

Thanks to all that replied. I'll give these suggestions a try. Brett

I have a customer with an MICS 6.1 software running an M7324 with 2 CAP modules as the main receptionists "console". It has started to lock up in that all LCD arrows come on and stay on preventing any call handling at the set. Sometimes the set re-initializes on its own and comes back. Over the...