Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by AlexTecmed

  1. AlexTecmed

    Accpac Dayend Error

    Thanks - will check and revert back. You 2nd part worries me as our current consultants recently re-installed (about 4 weeks ago) our software. (Will have them check to ensure all Service Packs are valid) - Currently 11:30pm at not at work - will let you know about DBSpy in the morning. ps...
  2. AlexTecmed

    Accpac Dayend Error

    Further info: I had tried running the IC integrity, but it does not complete and crashes out. It is not clear where the dayend stops. ie: it goes through PO and Receipts, then stops on IC Adjustments. The next time it stops at a PO entry. I have used RVSpy, but it does not indicate which...
  3. AlexTecmed

    Accpac Dayend Error

    Hi, I get the following error when trying to run dayend: 1/ Serial numbers do not match. 2/ Formatted serial number is blank. 3/ Invalid input. Location cannot be blank. 4/ Location does not exist in IC. 5/ Internal error. fetch (589 INTERLEV.C). Write down the message, leave ACCPAC and...
  4. AlexTecmed

    Internal Error. Document total mismatch

    Hi, Problem sorted - table was POPORI - which is the temp directory for day-end. Thanks again for your help.
  5. AlexTecmed

    Internal Error. Document total mismatch

    Hi, When using RVSPY - it only makes mention of POPORH. This table does not exist when using a Database editor. The tables I see with database editor are POPORH1 and POPORH2. Any further ideas. Regards, Alex.
  6. AlexTecmed

    Internal Error. Document total mismatch

    Hi, I seem to have the same problem- Used a database editor and deleted the entry from POPORH1 and POPORH2. Still no luck. Are there any other tables whereby the entry should be deleted from? Any help would be appreciated. Regards, Alex.
See more

Part and Inventory Search

Back
Top