Recent content by ajntek

my question was with the equipment listed above is it possible to activate the lines on the ip phones or do you need a Cisco router with vic cards or some other interface. Should I have posted this in a different section? ajNtek [ponytails]

Is no one familiar with this equipment? ajNtek [ponytails]

I am having a disagreement between a techncian and customer regarding the requirements for these phones. They have 508G IP sets and have analog lines punched down on the block. The lines are ported to their T1 circuit that is connected to an Adtran router. They have a Dell Powerconnect 3324 and...

exactly what I needed! Thank you!!! ajNtek [ponytails]

anyone know the feature code and hidden menu number to access the serial number of a startalk flash voicemail?? ajNtek [ponytails]

What version of software is the MICS, and the voicemail? The first thing you need to do is make sure they are compatible... ajNtek [ponytails]

Does anyone know what this event code is? It's not in any of the alarm & event code manuals. This is a reoccuring event code that looks like this: EVT 462-0161010101 54 2007/07/31 10:36 This is just an example there are several of these in the log... ANYONE KNOW? Thanks ajNtek [ponytails]

I have 2 sites with the same trouble. The callpilot is programmed to be answered by a standard auto attendant greeting. Intermittently, when an extension is entered the system generated recording "you have entered an invalid extension" it then brings you to the system generated prompt for the...

Try pressing * while the message is playing. There are 3 settings. This is only for the messages, not the prompts ajNtek [ponytails]

OK, this is a little confusing... I have a 0X32 with 7.0 software. Their lines are OPX off of an Option 61 switch. The main site with the Option switch recently installed a CallPilot 201i voicemail and we were to utilize the voicemail at the remote sites. The first 4 lines are working for...

Thanks for the reply..the cordless phone and base station came together, so I don't know what ss code it was given previously. I've gone through the set up several times and I get the same results every time. I verified the dip switch settings were correct (Down, up, down) any other ideas...

A customer of mine purchased a refurbished T7406. It did not come with the installation manual. I have already assigned a digital port and gone through the set up process as described in the user guide. When I get to 4. Set SS code I receive a Send Error! I reset the power and hold the OK button...

I thought so, I was hoping I was wrong. Thank You! ajNtek [ponytails]

Is there any way to get the serial number for the BCM 400 remotely? I pulled reports, but I don't see it listed... Thanks ajNtek [ponytails]

Assuming their extensions don't match their did's. You can either go in to the lines and see if they have assigned the extensions related to that line as the prime set. If not, you'll probably have to go in to the lines and get the recieve digits from each target line, once you find the one...