Recent content by Aggie91

Greetings, I currently have 2 2811s running 12.4 code that obtain and share OSPF routing information with each other. They are both in the same HSRP group. I recently added a 3925 running 15.x IOS which is not participating in any HSRP. I set up basic OSPF routing similar to the other 2...

My situation is a little different. I am trying to figure out how to PERMIT/ALLOW calling numbers, based on ANI information, as opposed to blocking. I thought maybe I could block on a negative result instead of permitting on a positive match, but I don't see where that is supported. Essentially...

Hi all. I currently have an ancient AS5200 with a T1/PRI card+digital modem card installed and hooked up to an Atlas800/600 system to allow me to test analog/PPP dial-ins from standard POTS v.92 type modems. I have been tasked with migrating that functionality to a 3945, a VWIC2-1MFT-T1/E1 and...

I put this over at the Cisco modem forum but that doesn't get much traffic. I have the WIC in a 2921. When I telnet into it, the first character I type does not show up. When I type the 2nd character, the 1st then echoes. Typing the 3rd character then causes the 2nd to echo, etc. This happens...

I am running vpnc as an ipsec xauth client against a remote Juniper SSG20 running screenOS 6.1.x I appear to be establishing my Ph1 and Ph2 portions successfully, but subsequently cannot get anywhere beyond the SSG20 with my client. I can ping the IP pool host he has been assigned (natch) and...

Somewhat related to the password bypass, anyone know of a way to completely reset the entire 450 to factory defaults? I had a situation where Telnet login was defined as going through a RADIUS server. The problem here was that there was no server IP address or any other information defined in...