Recent content by aertle

If you are makeing a Loop back Cable then use a Dw8 Cable or Cat5 W/ a RJ45 end and loop the pins 1-4 & 2-5 (W/O- B & O - W/B). If you are useing a 103 block then Loop 1-3 & 2-4. Both just cross over the Transmit to the Recieve.

Make sure that you have trunk 2 trunk transfer and remote forward enabled on the extention. Also make sure that your LS disconect is set to YES. You will find it under Lines&trunks -> TT/LS DISC -> LS Disconect -> YES. Either one of these will stop it from working. Hope it Helps.

Goto the Admin. phn or with SPM, got to Maitnence -> PORT -> PORT -> RS232 Port 1 -> Reset -> Yes. THis will reset the SMDR port. The connection settings are as important as the Reset. Make sure that your termonal Emulation program is set 1200-8-none-2-none. Hope this helps. If this doesn't...

If you are going to do a system renumber then you need to start with the basics, you need to understand that NO 2 extentions in a system can have the same #. So if you are going to move extn. #'s then you must clear them first. Work with 2 numbers at a time untill you understand the entire...

The SMDR/Admin pin out is as follows. Useing a RJ45: -Pin 1- Not used -Pin 2- DSR= DATA SET READY -Pin 3- DTR= DATA TERMINAL READY -Pin 4- GRD= GROUND -Pin 5- RxD= RECIEVE DATA -Pin 6- TxD= TRANSMIT DATA -Pin 7- PTS= REQUEST TO SEND -Pin 8- Not Used A 355AF adapter just takes a RJ45 to a 25 pin...

Kevin, there are 2 possible problems that are going on here. the first one is dealing with your phn lines. If you and not recieving "Answer Supervision/or reliable disconect", whatever they want to call it. A way of testing this is to make a phn call and let the outside party hang-up...

www.avaya.com/direct Item #6180-DW2 $103

SSA is a "copy" fo the system access for the originating (base) phone. when programing the SSA button you must be in Cntr-Prog, (console or SPM) for the Extn that you are putting the SSA buttons on. IE.the Boss is X-105, Sec. is X-120. Go into Cntr-Prog for X-120. Find the...