Recent content by aarenot

Tested with the only ext connected being the butt set at the phone system, and it still did it, and no paging speaker in the phone room.

Any help would be appreciated. Using intercom 70 does not seem to have the issue, intercom *70 does the loud noise.

Tommy! Thanks for the help, I had to work a few more setups similar to this on this site, not exactly the same, but it certainly helped to know how this one works exactly. Much appreciated.

intigrant, Yes, Line rings 201, if busy, or no answer, goes to mailbox 203. However 201 has another line which rings to it which must still go to mailbox 201. However this call does not ring x203, just goes to vm for x203. amriddle. It sounds like you are saying to create a group...

I have a request from a customer for x201 to ring on an analog pots line, but if busy, or unanswered to go to x203 vm box, and both of these exts have their own voice mail box. The system uses embedded voice mail, not vmpro. Any suggestions, I have not done that much set up with embedded...

I agree, I mispoke on the screw type, and thanks for the help from everyone.

The screws that go into the rack are not the type I am looking for. The machine screws are the ones I am looking for. They screw in flush, and hold the bracket to the IPO. Flat head, flush head as they are countersunk holes, and machine screws. I guess maybe I needed to be more clear.

My distributor wont respond with the screw specs, Avaya wont respond with the screw specs after 2 days to atac. I guess they don't care.

That is the style of pan head screw. What I do not know is the size. That is not the same size, or the exact screw. This seems to be of no use here, I am just going to order the $60.00 wall mount kit again, and just use the screws out of it, and throw the rest away.

This type of screw. http://files.engineering.com/getfile.aspx?folder=488589c3-f785-4111-a646-0e0aad859cf9&file=72103-2T.jpg

The screws I am talking about are the flat head screws that when screwed in are flush with the surface. The flathead screws are the ones I need. The head would be flush, not sticking out. They are the only flathead screws in the mix that I am aware of...

I am speaking of the flathead screws, not the screws for mounting the devices to the wall.

Those are the flatheads that sit flush with the outside of the unit?

tech lost the flathead, or pan head screws from the wall mount kit. Anyone have any idea what size these are so I can get some ordered?

HAVENT HAD TO CHANGE THE DISPLAY NAME ON AN ANALOG PORT ON A DK280 IN SOME TIME AND CAN NOT RECALL HOW TO DO IT. ANYONE RECALL HOW TO DO THAT? IT IS A PUMP PHONE AT A TRUCK STOP, SO THEY NEED TO KNOW WHICH PUMP IS CALLING ON THE DISPLAY BEING CALLED.