Recent content by A2Xprt

Great, thanks. I'll check it out now.

I'm trying to set something up here. We have two DSL lines as we have combined households. Here's the deal. Router/Gateway A (192.168.1.1) is connected and DMZd to a Cisco RVS4000 VPN router. Computers can go on the net and life is good. Router/Gateway B (192.168.2.1) when connected we get...

Thanks!

After researching on the web, I see the TN429 DIOD Pack can provide Caller ID. Can this pack work on a G3v6i.03.2.239.7? If so, any limitations/issues? If not, what options do I have for providing CID over LS trunks? Thanks,

@sstren Great find. But doesn't the NAM use a type III or are they one in the same? Let me know if this does the trick for getting the speech recognition working. Thanks!

@sstren: I'm still trying to locate an additional MS-PEC card to enable this capability. I haven't forgotten about this yey, as it is on my priority to-do list. From what I gather based on the experts above, this is all I need.

Assign outside trunks to pool. Assign pool to ATA DN. Dial 9 to access outside trunk group.

Quick question... Can someone explain the TTI status in detail? I did a <list config sta> and expecting to see some Us for unassigned, I see alot of t's. When looking at the <cha sys feat> screen, I see Enable TTI set to Y. I haven't changed anything on this as there was a Wraning to see...

I finally had some time to play and log into the switch. Using Procomm+ as a 4410 terminal I was able to obtain it is a G3V6i.03.2.239.7 I was able to log in using the inads login. Can I tell what features are available by this login? I know I need the init login to add features, but I would...

Thank you and thank you for the info. Please keep more info coming. This is great, and I'm very excited about it.

Thanks again,

Thanks billy for the reply. I guess I'll ditch the VT and use a PC with a terminal emulator then. I'll try those settings. Does the Definity require a special pinout on the TERM to SAT cable, or is it just a standard 25 pin serial?

I'm starting to take on a little project of tinkering with a Definity switch to learn it. I've got several 7444s, 8410s, and 8434Ds I've accumulated over the years. Im going to be given a Definity switch (it is an SCC type) so I decided to play arounf with it. I can punch the 25pair tails down...

Curlycord: I have confirmed that I do not have a PEC card in slot 4. I only have a PEC card in slot 1, hence the 16 channels. I guess I will need to order one and install. Then, I should have the option of enabling the Speech Recognition, correct? 2 Channels will be fine. Also, where did...

Thanks Curlycord, I will see what slot my existing PEC card is in now. Currently I have 16 channels and 64MB RAM on the NAM, so I think I at least have the RAM covered.