Recent content by a228380

hi tony I tried all of the suggestions and get syntax error almost all the time. basically the creator of the document wants to limit the choices which is why they probably used bookmarks.

Hi tony yes we are on the same page, I always get zero even though my bookmarks have values. If I do REF (dropdown1) which is the name of my book mark it will display the value 2 which is what the user entered for bookmark 2. but when I sum them or average them I always get zero as if it is...

I can not seem to locate where you do this. in msword, I did insert field but I can not locate calculation as a type can you elaborate?

i have a word documents that has 7 book marks and in bookmark8 I would like to display the average of the value of the 7 books marks but can not determine the syntax I need to make this occur. the 8th bookmark does not have to be a bookmark it can just be a field

hi I had massive problems when using the HP scsi controller I purchased with the loader. Returned the hp card and purchased and adaptec and all problems went away.

ensure that all users and the po have rights to the restore area

hi I was on enterprise server and you can do ssl but we ran into a small problem. we encrypted the url but if someone book marked a directory lower than the url they could still get in un-encrptyed. if you encrypt the whole server this will not be a problem. I think if the server is named the...

hi marv we have the setup you desire implemented but on an all novell environment but it really will not matter much. the webserver is in the dmz we opened ports between the webserver and a server inside the lan that is running the agents which then communicates with the po's also on the...

I know this is way after the fact but I had all kinds of problems with my cpq msl5000 tape loader. turned out the hp ultra scsi card with the lsimptnw.nlm driver was the prob lem. switched to onboard scsi card it worked fine, replace hp 320 ultra card with adaptec 320 worked great. arcserve...

I always seem to have 157 *.dtl files in the dbscan directory. I have set the merge time to run 23:59 hours per day, bumped up the settings in bti.cfg. But it never seems to merge all of the files. It appears to be merging files based on the messages I see about merge complete on the console but...

try running the structual check on her mail account from console one.

hi I had the same problem and it was caused by the version of the agent, I eventually had to down grade. this began occuring when I applied an arcserve patch to the client agent. I think this began when I went from version 252 of the client to version 272 and had to roll back. make these...

I have an excel sheet that I have password protected for both read and write when I open it it prompts me for the password (this is fine) then it prompts me saying it is reserved by "username" (one of our users) and prompts for the write password( how do I change the name or get it to stop...

I set up two user defined fields cell phone and home phone. I populated the fields in console/nwadmin. In the groupwise client I can add columns to my address book and select these two fields and the values of the fields are displayed. When I use webaccess and search the address book the...

I would create a domain and get away from work groups and then you would not have to create the users account on each workstation. good luck