Recent content by 3wsparky

i shall give this ago when i get to the laptop again , looks quite promissing , thanks

I have just installed 2k pro on an oldish laptop , all good apart from the the shutdown it doesn't power off , i know this is an acpi thing which i have now spotted disabled in the bios , question is the o/s is on the laptop now , is there a regedit or something that will allow me to enable...

research the ip helper command for cisco ios it should be in your switch config to allow devices on different vlans to obtain an ip address.

i downloaded a version of this but didnt seem to be able to get it to work , what info do you have on the product ?

thats the one , thanks

routing cost path issues , we had a link between our sites up graded , we now see traffic routing to the other site then back to our hq before it goes to the gateway , i have found the following ................ D*EX 0.0.0.0/0 [170/2585856] via 172.30.180.202, 2w2d, GigabitEthernet5/2...

When you install XP for the first time it goes through a setup process ie how can i connect to the internet etc , well it plays like this background sound thats quite easy on the hear while setting up the bits and bobs , anyone know where that sound is stored or what microsoft call it ?

the engineers i saw using this app were BT people in the uk know who they are , (scum of the earth ) only joking some of them do have hearts , clearly this is an in house app and i was just wondering if anyone else had seen it or maybe even used it ?

the basic horid gray buttons and splash screen before it loads , very good app but clearly a basic in house developed app with out any more work done than required

wheres the dhcp server live if its the one on that config above then you need to remove the ip helper address as its pointing to another dhcp server

anyone seen what there engineers use to test wan circuits i have seen two engineers use a custom app that allows you to send 10 50 or 100 Mb file , and logs the results of the transfer to calculate the speed etc any ideas , does anyone have or use this sort of thing ?

I have seen BT use a custom made app looks very vb like to test our circuits they simpaly enter the address of the other engineers laptop both connect to each other and then can run network tests like transfer a 10 50 or 100 Mb file which then shows stats of the speed peeks etc anyone know of...

i have been playing with the outlook forms but with no success , one of two ways would do it for me , either a html form that allows java inside it , or a vb form but im not expert and cant get the code to work right Option Explicit 'Set to True to make the password case-sensitive Const...

thanks moodycow that worked and now im able to access the allied being that the fiber to copper cisco is up i can see why the allied was set to 1000 full - in other words negioation was turned off at one end , both ends have to be enabled for negioation to work

i have a cisco 3500 and the fibre interface wont come up i have issued the no shut if i fibre cable from a 3500 to a 3500 it comes up if i fibre an allied to allied the fibers come up but if i fiber from allied to the cisco it wont come up have tried swapping tx and rx around any ideas...