Recent content by 17seconds

Thank you, Pojabo. :-) ..if it weren't for this forum..

I have a number of embedded textboxes in my main text. When I attach the main text to the baseline, the embedded textboxes seem to lose their runaround and some of the main text disappears, apparently under the embedded box. The same happens when I first attach the main text to the baseline and...

<bells><drums> tadaaah </drums></bells> Indeed, when I downsize the width of the smaller textbox from 98 mm to 97.9 mm, the box embeds perfectly in the main textbox and flows with the text that surrounds it. Thanks so much for guiding me through this. Cheers. 17seconds

Hmm...we're almost getting there, now. The small textbox I want to embed is exactly as wide as the target textbox. When I downsize the width a little before I cut and paste it, the main text doesn't overflow. BUT...when I then restore the initial width of the small textbox, the main text...

Unfortunately, no. I tried adding new pages at the end of the document (since the overflow-square appeared on the final page). When I link the new pages to the text chain, the overflow square moves to the new final page. There should be more than enough room for the text, though, since the...

Thank you for your reaction, Foamcow, but when I follow your advice, the text after the position where I pasted my textbox disappears, and on the final page Quark shows the little red crossed square. *puzzled*

Within the main text in a quark document (6.0 passport) I created a textbox for a small paragraph of text. Now I want this textbox to move with the main text, so, when I make changes to the main text above, it stays in the relative position where I put it. Any help would be greatly appreciated.