Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Database lost during upgrade- convert to prior level to recover DB.

Database lost during upgrade- convert to prior level to recover DB.

by  richtech  Posted    (Edited  )
Original software level was MICS DR2.0, Converting to MICS-XC 5.0. Database came up default.// With 5.0 installed, power down system and power right back up. After load complete, log on and enter FEAT ** STARTUP. Answer questions OK till Apply templates, answer OK allow to load for 20-30 seconds then power down. Pull 5.0 software. Without any software cartridge, power up allow to load for 30 seconds, then power down. Add DR2.0 software and load for @ 30 seconds power down and then power back up and allow to load completely. Reload saved database- shame on you if you didn't save the DB before the conversion.
Register to rate this FAQ  : BAD 1 2 3 4 5 6 7 8 9 10 GOOD
Please Note: 1 is Bad, 10 is Good :-)

Part and Inventory Search

Back
Top