Here's a list of common/frequently used commands on Tadiran Coral (FlexiCom & IPx) PABXs. As the structure of the PI (Programming Interface) has several ways to access it I will write each command in several ways. The different ways are: (the example below is to display all features on a specific xtn)
* From the ROOT menu using menu structure 0 <cr> 4 <cr> 0 <cr> 1 <cr> xxx <cr> xxx <cr> <cr>
* In a single string (using DAA from anywhere) FEAT,0,1,xxx,xxx,,
Depending in your knowledge and skill level you can choose to use either option. For beginners it's best to use the DAA but then enter each command at a time. Once you know the system and what prompts to expect then you can use the single string option as it's very quick. I will list the single string way as it takes up a lot less space - for beginners just take out each part and press enter after each so you can see what's what.
Remember, there's no substitute for a proper training course and the manual!
** Backup system to disk/flash ROOT,0,10,2 <cr> then depending on system type choose disk or flash and following prompts
** Restart system ROOT,0,0,0,2,0 <cr> then <cr> until you get the following prompt UPDATE *warning* system init (Y/N)? and type Y and <cr>
That's about all I can think of at the moment. Obviously there's a lot more but these are common commands. You'll notice that most of these commands are to display things - you'll spot that entering 1 is to Display and 0 is to Update so just substitute 1 for 0 if you want to change anything.
One last thing - from anywhere type HELP <cr> and it will display all DAA options. Any of these can be type from anywhere in the PI.