Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

How can I get the description of an error-code, without the books?

Meridian Manuals

How can I get the description of an error-code, without the books?

by  Cawho  Posted    (Edited  )
While you are in a Load use "!" to get a ">" prompt and type in ERR (followed by the system-message you got) here is an example:

> ld 20

REQ: new
TYPE: 2616
TN 120 0 9 0
SCH0127 <--------how come ?????
TN !
>err sch127 <------type in the code like this!
>

SCH0127
Terminal already exists. <------- answer, oh!


Severity: Info
71 0 4 6 <-------- you continue where you were!
DES test
CUST 0
...etc

You can use ERR when you aren't in any LOAD.
Register to add this FAQ to your archive
Register to rate this FAQ  : BAD 1 2 3 4 5 6 7 8 9 10 GOOD
Please Note: 1 is Bad, 10 is Good :-)

Part and Inventory Search

Back
Top