×
INTELLIGENT WORK FORUMS
FOR COMPUTER PROFESSIONALS

Log In

Come Join Us!

Are you a
Computer / IT professional?
Join Tek-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!
  • Students Click Here

*Tek-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Students Click Here

Jobs

Norstar NAM

Laptop/PC Serial Port Connection to NAM by Arr
Posted: 3 Mar 03

To connect your laptop using the serial cable to a NAM 3.0 can go one of two ways. Because of its age it was the change point where the gui was resident in the NAM and where you needed to set the dial up properties in your laptop. Here is the newer config method for NVM 3.0 and up:

1. copy NVMPPP2.inf (it comes with NVM Manager Software) to your hard drive;

2. go to the control panel and double click the 'modems' iclon. If a modem has previously been installed, click on the 'add' button. If a modem has never been installed, an 'install new modem' dialog box is presented right away without being prompted to press a button for 'add', 'remove', or 'properties';

3. On the 'install new modem' dialog box, check 'don't detect my modem' box;

4. click the 'next' button;

5. click on 'have disk';

6.in the next dialog box enter the path to the file that you copied in step one;

7. click on 'direct serial connection';

8. click on the 'next' button;

9. click on the port where your direcct connection is going to be on this windows PC - choose your laptops com port here);

10. windows takes a few seconds to install this new device driver. After it is done, click the 'finnish' button. The title of the modem, 'direct serial connection' should appear in the next window;

11. Click 'OK';

12. go into dial up networking and make a new connection;

13. when the dialog box comes up select the direct serial connection as your modem. Give a name for this type of connection in the 'type a name for the computer you are dialing ' field. An example name would be 'NAM Serial Port' and click configure;

14. set the speed to 19200;

15. choose the 'connection' tab and remove the check for   ' wait for dial tone before dialing' and change the 'cancel the call if not connected within 60 secs' to be 0 secs. DO NOT REVOVE THE CHECK FROM THE BOX!!!!

16. proess ok. Then click on the 'next' button. It does not matter what you put in for a phone number. At this time go to dial up networking and choose the properties  for this new connection that you have made. Choose 'server type'. Although the server type must be PPP, and TCP/IP must be an allowed network protocol, the other settings such as 'log on to network', 'enable softwer compression', 'require encrypted passwrd' do not matter for the TCP/IP settings. Ensure that 'server assigned IP address' and 'server assigned name server addresses' are all checked. Ensure that 'use IP header compression' and 'use default gateway on remote network' are also checked;

17. reboot - test.


Back to Nortel: Norstar systems FAQ Index
Back to Nortel: Norstar systems Forum

My Archive

Close Box

Join Tek-Tips® Today!

Join your peers on the Internet's largest technical computer professional community.
It's easy to join and it's free.

Here's Why Members Love Tek-Tips Forums:

Register now while it's still free!

Already a member? Close this window and log in.

Join Us             Close