Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

What is the power needed for a MICS

Norstar Power

What is the power needed for a MICS

by  jerryreeve  Posted    (Edited  )
Power consumption for a Norstar 0x32 is:
0x32 KSU 80 watts
Add 60 watts for each analog station module
Add 20 watts for each additional station module
Add 20 watts for each additional trunk module
Add 15 watts for each DID card
Add 10 Watts for each ATA
Add 5 watts for each SAPS
Subtract .5 watts for each digital set (less than maximum sets) not installed

Add 5 Watts for each Call Pilot 100
Add 7 Watts for each Call Pilot 150
Add 25 watts for each Startalk flash
Add 50 Watts for Norstar Voicemail 1DVC
Add 60 Watts for Norstar Voicemail 2DVC
Add 70 Watts for Norstar Voicemail 3DVC
Add 80 Watts for Norstar Voicemail 4DVC
Note: DVC: Digital Voice Card,
Register to add this FAQ to your archive
Register to rate this FAQ  : BAD 1 2 3 4 5 6 7 8 9 10 GOOD
Please Note: 1 is Bad, 10 is Good :-)

Part and Inventory Search

Back
Top