INTELLIGENT WORK FORUMS
FOR COMPUTER PROFESSIONALS

Log In

Come Join Us!

Are you a
Computer / IT professional?
Join Tek-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!

*Tek-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Jobs

AVAYA SBS (separate bearer & signaling) - call ID not sent

AVAYA SBS (separate bearer & signaling) - call ID not sent

(OP)
Hello,

I'm tryng to setup Avaya SBS trunk, to send signaling information (Caller ID and name) in calls through limited PSTN.

I created 2 SBS H.323 trunks on both sides (CM6 PBXs), SBS extension on receiving side, filled public-unknown-numbering table and assigned DID number on receiving PBX to station.

According to Job Aid document, SBS contains next steps:


1) station on PBX A calls SBS extension on PBX B, through SBS H.323 trunk
2) On PBX B, special SBS extension receives call with signaling portion (Caller ID, caller name) and send to PBX A phone number for voice bearer call (from public-unknown table)
3) staion on PBX A receives number for voice bearer, and call this number (via PSTN)
4) call arrives to PBX B via PSTN, and PBX B send call ID via SBS trunk to PBX A
5) PBX A send call ID in bearer call, using DTMF. SO, bearer call and signaling portion can be assigned in same call.


But, when I trying to make SBS call, everything goes fine, except call ID sending on PBX B (terminating node).

Where is point in setup, that i missed?

Here is trace on terminating node (SBS trunk):

CODE -->

LIST TRACE
time            data
16:24:20 TRACE STARTED 09/26/2017 CM Release String cold-00.1.510.1-21061
16:24:25     Calling party trunk-group 7 member 1    cid 0x3c27
16:24:25     Calling Number & Name 3307 Yaroslav 
16:24:25     active trunk-group 7 member 1    cid 0x3c27
16:24:25     dial 5555
16:24:25     term station      5555 cid 0x3c27 

on originating node (trace from station)

CODE -->

LIST TRACE
time            data
16:23:59 TRACE STARTED 09/26/2017 CM Release String cold-03.0.124.0-23382
16:24:24     active station      3307 cid 0x2191
16:24:24     G711A ss:off ps:20
             rgn:1 [106.125.2.81]:2176
             rgn:1 [106.125.22.11]:2080
16:24:28     dial 5555# route:UDP|AAR
16:24:28     term trunk-group 11      cid 0x2191
16:24:28     dial 5555# route:UDP|AAR
16:24:28     route-pattern  99 preference 1 location 1/ALL  cid 0x2191
16:24:28     seize trunk-group 11 member 6    cid 0x2191
16:24:28     Setup digits 5555
16:24:28     Calling Number & Name 3307 Yaroslav Pork
16:24:28     Proceed trunk-group 11 member 6    cid 0x2191
16:24:28     active service-link       cid 0x2192
16:24:28     dial ################ route:ARS 
16:24:28     term trunk-group 1      cid 0x2192
16:24:28     dial ################ route:ARS
16:24:28     route-pattern  3 preference 1 location 1/ALL  cid 0x2192
16:24:28     seize trunk-group 1 member 17    cid 0x2192
16:24:28     Setup digits ################
16:24:28     Calling Number & Name %%%%%%%%% NO-CPName
16:24:28     Proceed trunk-group 1 member 17    cid 0x2192
16:24:31     Alert trunk-group 1 member 17    cid 0x2192
16:24:38     active trunk-group 1 member 17    cid 0x2192
16:25:26     idle trunk-group 1 member 17    cid 0x2192 

RE: AVAYA SBS (separate bearer & signaling) - call ID not sent

is trunk 11 a public or private trunk under service type?

RE: AVAYA SBS (separate bearer & signaling) - call ID not sent

(OP)
Trunk 11 (SBS signaling) - tie type

CODE -->

change trunk-group 11                                           Page   1 of  21
                                TRUNK GROUP

Group Number: 11                   Group Type: isdn          CDR Reports: y
  Group Name: SBS test                    COR: 1        TN: 1        TAC: 6911
   Direction: two-way        Outgoing Display? n         Carrier Medium: H.323
 Dial Access? n              Busy Threshold: 255  Night Service:
Queue Length: 0
Service Type: tie                   Auth Code? n
                                              Member Assignment Method: auto
                                                       Signaling Group: 11
                                                     Number of Members: 10 

CODE -->

change trunk-group 11                                           Page   2 of  21
      Group Type: isdn

TRUNK PARAMETERS
         Codeset to Send Display: 6     Codeset to Send National IEs: 6
                                        Charge Advice: none
  Supplementary Service Protocol: b     Digit Handling (in/out): enbloc/enbloc


                                                   Digital Loss Group: 18
Incoming Calling Number - Delete:     Insert:                 Format:

 Disconnect Supervision - In? y  Out? n
 Answer Supervision Timeout: 0
                                      CONNECT Reliable When Call Leaves ISDN? n
             XOIP Treatment: auto    Delay Call Setup When Accessed Via IGAR? n





 Caller ID for Service Link Call to H.323 1xC: station-extension 

CODE -->

change trunk-group 11                                           Page   3 of  21
TRUNK FEATURES
          ACA Assignment? n            Measured: none
                                 Internal Alert? n        Maintenance Tests? y
                               Data Restriction? n     NCA-TSC Trunk Member: 1
                                      Send Name: y      Send Calling Number: y
            Used for DCS? n             Hop Dgt? n     Send EMU Visitor CPN? y
   Suppress # Outpulsing? n            Format: unk-pvt
                                             UUI IE Treatment: service-provider

                                                 Replace Restricted Numbers? n
                                                Replace Unavailable Numbers? n
                                                      Send Connected Number: y
                                                  Hold/Unhold Notifications? y
             Send UUI IE? y     Modify Tandem Calling Number: no
               Send UCID? y
 Send Codeset 6/7 LAI IE? y


 Show ANSWERED BY on Display? y 

CODE -->

change trunk-group 11                                           Page   4 of  21
                       QSIG TRUNK GROUP OPTIONS




   TSC Method for Auto Callback: drop-if-possible
           Diversion by Reroute? y
               Path Replacement? y
Path Replacement with Retention? n
        Path Replacement Method: better-route
                            SBS? y

    Character Set for QSIG Name: eurofont
               QSIG Value-Added? n

      SIP Reference Trunk Group: 

RE: AVAYA SBS (separate bearer & signaling) - call ID not sent

try filling in the private-numbering as retest

Red Flag This Post

Please let us know here why this post is inappropriate. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

Red Flag Submitted

Thank you for helping keep Tek-Tips Forums free from inappropriate posts.
The Tek-Tips staff will check this out and take appropriate action.

Reply To This Thread

Posting in the Tek-Tips forums is a member-only feature.

Click Here to join Tek-Tips and talk with other members!

Resources

Close Box

Join Tek-Tips® Today!

Join your peers on the Internet's largest technical computer professional community.
It's easy to join and it's free.

Here's Why Members Love Tek-Tips Forums:

Register now while it's still free!

Already a member? Close this window and log in.

Join Us             Close