I am working on a Nortel Norstar 4x8 with DR1 software. No passwords just the usual feature codes to enter the configuration and administration menus. I placed a new / replacement phone on the system it used the first available DN (27) in this case. I thought this might be because I placed it on port 7 first but no that is not it. I brought in another set. This became DN 28 even when I am sure I plugged it into port 2. Is there any way to get the original DN 22 back on port 2? Can sets be renumbered in DR1?
Thanks for your help,
Red Flag Submitted
Thank you for helping keep Tek-Tips Forums free from inappropriate posts. The Tek-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Tek-Tips forums is a member-only feature.