I have a CME PBX tail hanging off a CS1000 7.6 system and when the tail PBX dials the AC1 (9) they are immediately presented with fast busy tone. I turned on DCH monitoring and I can see the 9 come across the DCH on the main CS1000 PBX. I checked the PRI route but cant figure out what is wrong. A work around I have discovered is to change the ACOD on the CS1000 route to "89" which allowed the CME to access the outbound PRI on the CS1000. I would much rather have the tail PBX dialing 9 as the CS1000 does to access the outbound trunks, but again I cant figure out what is wrong or if it can be done. Please advise Thank you
Red Flag Submitted
Thank you for helping keep Tek-Tips Forums free from inappropriate posts. The Tek-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Tek-Tips forums is a member-only feature.