INTELLIGENT WORK FORUMS
FOR COMPUTER PROFESSIONALS

Come Join Us!

Are you a
Computer / IT professional?
Join Tek-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!

*Tek-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Jobs

Jobs from Indeed

How to tell if I need another PRI

How to tell if I need another PRI

(OP)
ON a BC50 system I am able to actually look at an active system status and see all 23 channels, calls in progress etc. Is there any way to see these stats on a MICS 7.1 XC so that I can tell if I am going to need another PRI? The only metrics I see are the Hunt Groups. I am mainly looking for when the PRI channels become ALL BUSY for incoming or outgoing traffic.

RE: How to tell if I need another PRI

MICS too primitive for that
You can ask your carrier to give you a traffic study.

________________________________________

Add me to LinkedIN

**New Allworx Forum**


=----(((((((((()----=
www.curlycord.com
Toronto, CAN

RE: How to tell if I need another PRI

(OP)
Thanks!

RE: How to tell if I need another PRI

Usually if you get complaints of busy signals and no free lines then that would tell you all channels are being used.

RE: How to tell if I need another PRI

You can setup an M7324 with Appearances of all 23 channels and observe activity. LINE001-023.

Marv ccna

RE: How to tell if I need another PRI

Marv I was thinking about that but was going to suggest another phone at reception for that but for the cost of doing that vs a study was close.
Ms Whiggins without the features might be disastrous.

________________________________________

Add me to LinkedIN

**New Allworx Forum**


=----(((((((((()----=
www.curlycord.com
Toronto, CAN

RE: How to tell if I need another PRI

(OP)
I tried to assign the lines to a set as suggested but I get an error that says: "PRI LINES CAN NOT BE ASSIGNED TO SETS"

RE: How to tell if I need another PRI

We already stated your software was to new for that per above.

Did you call the carrier yet?

________________________________________

Add me to LinkedIN

**New Allworx Forum**


=----(((((((((()----=
www.curlycord.com
Toronto, CAN

Red Flag This Post

Please let us know here why this post is inappropriate. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

Red Flag Submitted

Thank you for helping keep Tek-Tips Forums free from inappropriate posts.
The Tek-Tips staff will check this out and take appropriate action.

Reply To This Thread

Posting in the Tek-Tips forums is a member-only feature.

Click Here to join Tek-Tips and talk with other members!

Resources

Close Box

Join Tek-Tips® Today!

Join your peers on the Internet's largest technical computer professional community.
It's easy to join and it's free.

Here's Why Members Love Tek-Tips Forums:

Register now while it's still free!

Already a member? Close this window and log in.

Join Us             Close