Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Sync Media Command

Status
Not open for further replies.

wpetilli

Technical User
May 17, 2011
1,877
US
On my core CM system I did a command 'disp sync media xx' (x is the number of the lsp media gateway). I don't ever recall that page being administered... where does the information there get populated from?

I have another core CM that has no information in those commands.
 
Code:
Command: list configuration ds1

                       SYSTEM CONFIGURATION - DS1 Circuit Packs

Location   Code    Vintage     Signaling         Name              CSU MOD

002V1      MM710BP HW11 FW044  isdn-pri          PRI Quest         n/a
002V2      MM710BP HW11 FW044  isdn-pri          PRI to IPoffice   n/a

show mg list_config
show sync timing
clear sync interface primary
clear sync interface secondary
set sync interface primary
set sync interface secondary
set sync source primary
set sync source secondary
set sync source local
set sync switching disable
set sync switching enable
MG-002-2(super)# show mg list_config

SLOT  TYPE   CODE   SUFFIX  HW VINTAGE  FW VINTAGE   VOIP FW
----  ------ -----  ------  ----------  -----------  -------
v0    G700   DAF1   A       00          25.40.0(B)   70
v1    DS1    MM710  B       11          44           N/A
v2    DS1    MM710  B       11          44           N/A
v3     -- Not Installed --
v4    DCP    MM712  A       3           8            N/A
MG-002-2(super)# show sync timing

SOURCE     MM                   STATUS                   FAILURE
---------  -------------------  -----------------------  ---------------
Primary                         Not Configured
Secondary                       Not Configured
Local      v0                   Active                   None

Active Source: v0               Sync Source Switching: Disabled
MG-002-2(super)# configure
MG-002-2(configure)# set sync interface primary v1
MG-002-2(configure)# set sync source primary
MG-002-2(configure)# set sync switching enable
MG-002-2(configure)# show sync timing

SOURCE     MM                   STATUS                   FAILURE
---------  -------------------  -----------------------  ---------------
Primary    v1                   Active                   None
Secondary                       Not Configured
Local      v0                   Standby                  None

Active Source: v1               Sync Source Switching: Enabled


A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"
Avaya. Too little or no help? Expensive?
For FAST switch support at bargain rates, give bsh a call.

bsh

40 years Bell, AT&T, Lucent, Avaya
Tier 3 for 30 years and counting
[URL unfurl="true"]http://bshtele.com[/url]
 
Should the sync source be the slot where the DS1 MM is located or the V0 -- local.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top