I'm trying to do an upgrade to a CS 1000 to Rls 7.5 but when I upload Linux it does not recognize the network ports on the CPMGS board.

Any suggestions?

What ports are you using? Should be the 1E and 2T, ports on the bottom, wired to your ethernet switch.

Thanks KCFLHRC

Does are the exact ports that I'm using, this is what I get:


tarting sysstat: Calling the system activity data collector (sadc):
[ OK ]
Starting background readahead: [ OK ]
Bringing up loopback interface: [ OK ]
Bringing up interface eth0: Device eth0 does not seem to be present, delaying initialization.
[FAILED]
Bringing up interface eth1: Device eth1 does not seem to be present, delaying initialization.
[FAILED]
Starting portmap: [ OK ]
Starting NFS statd: [ OK ]
Starting RPC idmapd: [ O

belpbx.pbx.local login: admin2
Password:
/opt/nortel/base/bin/check_fullduplex failed: exit code 1
To access the UCM Web page, go to:
UCM URL: http://<FQDN|IP>
Network issue detected: cannot assign ip address to the eth0 interface.
Network issue detected: cannot assign ip address to the eth1 interface.

Have you installed the 3 base linux patches yet? Right now all it know is it has linux. It has no idea it will be a Nortel box. I wouldn't be too concerned yet until you get it patched and deployed.

Do you have these 2 ports plugged into an ethernet switch? If you do not it will give you errors similar to this.

the linux patches are intalled and the 2 ports are connected to the switch.

Do you have link lights on the switch?

Have you configured the Media Gateway portion of the card?

there is link and MG is configured

I can honestly say I have never seen what you are describing. Is the machine deployed? Obviously you should be deploying CS,SS,EM at the very least. Is there a database in it? Does anything work? Can you ping the addresses from your laptop?

any display errors on the cards LED?
whats the NT number and version of the card?

__________________________________________________________
Find a job you love and you'll never work a day in your life. - Confucius

No display errors and the number is NTDW59BAE6 Rls 2

? bios reset?
LW or boot code ?

__________________________________________________________
Find a job you love and you'll never work a day in your life. - Confucius

When I first trying to install Linux, I put in all the information, IP and that is when I get the message the it cannot find the network ports or they are not initiazed.

In this case, I would connect a crosscable between E and T Lan and restart the CPMG again.

*******************
Bringing up interface eth0: Device eth0 does not seem to be present, delaying initialization.
[FAILED]
Bringing up interface eth1: Device eth1 does not seem to be present, delaying initialization.
[FAILED]"

********************

If the error still exists, maybe your Hardware can be faulty.

Meridian, Callpilot, CCM (Symposium) from Germany