Hi Everyone,

Quick question on MICS system with 4.1XC. The system had 4.1 and upgraded to 4.1XC to allow 2 fiber cards. Upgrade completed and smooth, upgrade second fiber cards both in and went smooth. Where I run into a problem is with the expansion M12X0 trunk module is not seen by the system and when I login to the fastrad and norel software is seem to appear as a station module. The only trucks I see are the orginal 2 trunk cards on the main system on module 2. Does the M12X0 need to be in a certain port on the fiber card and does the first 1 or 2 card matter. Don't want to move existing M016 without knowing becuase i'm sure this will change the DN/port assignment on sets? The second question is once the system see the M12X0 are the trucks assigned to 049 -053. I know the first 8 are on 1-8.  Thanks so much for help, Mike

System Config
MICS with 4.1XC
2 X 4 port Truck cards in main unit
2 X Fiber 6port cards in main unit
7 M016 Station modules  (6 on fiber card 1 and 1 on fiber card 2 all working)
1 M12x0 trunk module with 1 x 4 port trunk card.(on fiber card 2 tried different port no luck)
1 Callpilot 100 40 mailboxes
1 Fastrad for backup and remote access
100+ sets M7208, T7208, M7324, T7316E ....

Sorry for the typos on trunk.  ( I know it's not a truck)

Mike

Install Trunks mods only to exp card on the right.
I was just reminded of this too lately.

Turn set relocation on and move station mods to the left if need space.
 

=----(((((((((()----=
curlycord
www.curlycord.com

 

Also, to keep continuity in line numbering you need to add trunk modules in slot 2 from the top port and work down.  Station modules should be added from the bottom port and work up.

Brian Cox
Oregon Phone
http://www.OregonPhone.com
http://www.linkedin.com/in/briancox1952

 

Top 2 ports on the 2nd expansion card with 4.1 software are reserved for Companion.

Marv
www.telemarv.ca

Thanks Curlycord... worked like a charm!!

Thank for all replies!