Fiber Pull Fiber Pull OneSourceTelecom (Vendor) (OP) 5 Apr 11 21:34 Just pulled in 3 runs of 950',600'and 350' at football stadium. pulled through provided underground conduits, to all buildings. Now need to terminate.Looking for Current Rates..... RE: Fiber Pull mforrence (Vendor) 6 Apr 11 05:32 Your question isn't quite clear. Are you looking for the rate that you will pay to have another vendor terminate, or are you asking what you should charge your customer? Know that the fiber type and connector type will be pertinent.Mike RE: Fiber Pull kwing112000 (Vendor) 6 Apr 11 06:54 Also where are you located. Kevin WingACSS Small and Medium Enterprise (SME) CommunicationsACS- Implement IP OfficeACA- Implement IP OfficeCarousel Industries RE: Fiber Pull OneSourceTelecom (Vendor) (OP) 6 Apr 11 20:08 Basically loking for average rate to charge for pulling and terminating RE: Fiber Pull mforrence (Vendor) 7 Apr 11 08:37 We would charge an hour per cable end to prep plus twenty minutes per strand to terminate, label and test. Plus termination hardware. Pulling is like pulling any other cable.Mike RE: Fiber Pull Telecomp9434 (Vendor) 11 Apr 11 18:09 Depending on the number of strands, we usually charge a minimum of 4- hours for Fiber Optic termination. Yes, pulling fiber is the same as any other cable and you can get just about anyone to pull cable, however when it coems to terminating the fiber, the list of qualified fiber optic installers becomes very short.Sal- www.Telecomp-inc.com"Voice and Data Solutions"