17 Jun 10 10:59
In my company, we have a pix 515e since 2005.
It has three interfaces (LAN, WAN, DMZ).
We just add a new adsl internet access and I want to add a new ethernet card on the PIX (WAN2).
I want to use one internet access (the guaranteed throughput)
on the first wan interface and the second internet access (the non guaranteed throughput but higher bandwidth) on the second new.
My questions are the followings :
Is the hardware of my pix 515 compatible with a pix-1fe card ?
Can I configure a wan interface (WAN1) to output to a specific internet access and a second (WAN2) to output to a second internet access ?
Here is the "show version" command result of my PIX :
Cisco PIX Firewall Version 6.3(4)
Cisco PIX Device Manager Version 3.0(4)
Compiled on Fri 02-Jul-04 00:07 by morlee
ciscopix up 129 days 1 hour
Hardware: PIX-515E, 32 MB RAM, CPU Pentium II 433 MHz
Flash E28F128J3 @ 0x300, 16MB
BIOS Flash AM29F400B @ 0xfffd8000, 32KB
0: ethernet0: address is 0013.1968.e8e6, irq 10
1: ethernet1: address is 0013.1968.e8e7, irq 11
2: ethernet2: address is 000e.0c68.dbb1, irq 11
Maximum Physical Interfaces: 3
Maximum Interfaces: 5
Cut-through Proxy: Enabled
Inside Hosts: Unlimited
IKE peers: Unlimited
This PIX has a Restricted (R) license.
Serial Number: 808533317 (0x30313d45)
Running Activation Key: 0x8efae397 0x587c7a35 0x7c90ec8c 0xecfe2f4a
Configuration has not been modified since last system restart.
Could you help me.
Thanks a lot.