DSPUSRPRF USRPRF(*ALL) OUTPUT(*PRINT) DSPUSRPRF USRPRF(*ALL) OUTPUT(*PRINT) BeatrixKiddo (ISP) (OP) 20 Aug 09 16:34 Hello, I have been looking for a reference to know which columns you could get running the command:DSPUSRPRF USRPRF(*ALL) OUTPUT(*PRINT) But not been able to find out the names and order of the columns. Does anyone hase an idea? RE: DSPUSRPRF USRPRF(*ALL) OUTPUT(*PRINT) lkmalee (IS/IT--Management) 20 Aug 09 16:50 It appears to me that you cannot successfully run this command as written (at lease, you can't on V5R3). It appears that you can only use the *PRINT parameter on a single user profile name i.e.CODEDSPUSRPRF QPGMR OUTPUT(*PRINT)You can see the fields generated if you use the *OUTFILE parameter: CODEDSPUSRPRF QPGMR OUTPUT(*OUTFILE) OUTFILE(MYLIB/MYFILE)then use a query tool to inspect the output file MYLIB/MYFILE.Hope this helps. RE: DSPUSRPRF USRPRF(*ALL) OUTPUT(*PRINT) tcsbiz (Programmer) 21 Aug 09 10:41 That combinaiton is not valid as explained in the message information for the error you get when you try it:CODE Additional Message Information Message ID . . . . . . : CPD22AE Severity . . . . . . . : 40 Message type . . . . . : Diagnostic Date sent . . . . . . : 08/21/09 Time sent . . . . . . : 09:36:21 Message . . . . : TYPE and OUTPUT values not valid with USRPRF(*ALL). Cause . . . . . : USRPRF(*ALL) is valid only when *BASIC is specified for the TYPE parameter and *OUTFILE is specified for the OUTPUT parameter. Recovery . . . : Either specify a specific user profile name for the USRPRF parameter or change the TYPE value to *BASIC and the OUTPUT value to *OUTFILE. As lkmalee said, send the data to a file and query the file. You can try each option for TYPE and see what you get. There may be a book on IBM's website that explains the fields.